Electronics Forum | Mon Mar 19 23:35:10 EDT 2007 | bvdb
Hi Pete, I was using only the small and medium nozzles but it happens on both nozzles. No error message unless the delay went past about 5 seconds then a Q servo error and machine stops. Pressing reset and run enables it to continue although it th
Electronics Forum | Wed Aug 24 11:32:08 EDT 2016 | mnorthey
Did you get your problem solved? I don't remember exactly what I did for that problem but it may have involved changing a servo or driver card. I do have a copy of the calibration/repair manual if you want it. I also have some Nozzles NC-1410 (1.0
Electronics Forum | Wed Oct 29 20:58:31 EDT 2008 | rmitchell
Hi, Our Fuji CP6 table is rising up abruptly when it unloads a pcb after populating it. It makes a clunking noise much louder than before. I don't see anything that has changed or gets in the way as far as the table rails lining up with the exit c
Electronics Forum | Fri Mar 23 03:53:44 EDT 2007 | Guest
Hi Bert , I dont know much about IP , since I partnered our Fuji CP 6 with Siemens .At any rate, can you check your flat ribbon cable of your Ip's Head. I assume there one wire that is nearly breaking. During movement, head servo controller experie
Electronics Forum | Thu Jan 11 19:18:24 EST 2024 | madisreivik
Hello ! FUJI IP3 left head sometimes places component with rotation error. Vision processing SHOWS that component needs rotation Mechanical side is checked, looks fine. Also, changed servo, no effect. It happens randomly, maybe 1 part from 30. It
Electronics Forum | Fri Mar 13 16:23:10 EDT 2009 | rodrigo
We're going to swap SA-4 and 6 but it is going to take a few days. Thanks for all the help. Follow up: We swapped SA-7 and SA6 (because SA-4 was different). The problem stayed with the original amp. so we're looking for a replacement. Our buyer is h
Electronics Forum | Wed Mar 19 15:59:40 EDT 2008 | rmitchell
Hi, I am having some problems with my CP6 placement changing in the Y axis. I had to move all parts by +.12mm this morning. Then after 20 boards the placement shifted too high by about .12 mm The IP stayed the same with the same pcb's and fid coo
Electronics Forum | Tue Jul 12 03:57:55 EDT 2005 | woodglass
Hi, In the CP6 propers, there are values: PCB Check Position X, & PCB Check Position Y. These are the servo counts that the X/Y table moves to when checking if a PCB exists on the table. Your sensor does not detect a PCB, probably because when checki
Electronics Forum | Fri Jun 22 11:02:13 EDT 2007 | gregf912
I have a CP642E machine that will not function if auto adjust is enabled in Part Descriptor. Symptom: Auto pick offset causes machine to pick part off center to the point of going to end of part after several picks. This only happens to parts that ha
Electronics Forum | Tue Jul 11 23:28:59 EDT 2006 | donb
Hi All, I have a continuing problem here with mis-alignment of parts on one of our Fuji CP-3 machines and I thought one of you esteemed engineering types may be able to give me a clue as to where the problem might lie. I have a Fuji trained enginee
