Electronics Forum | Wed May 26 05:58:50 EDT 2010 | chrislyttle
Hi, first time posting on here. We've recently acquired additional Fuji machines to add to our line and have moved premises to a new factory. I've been trying to set up a new factory line in Line Editor to use two of our existing machines (Fuji GSP
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
Electronics Forum | Mon Jun 05 22:40:40 EDT 2000 | Dean
...well, if I had Fuji in on 4 occasions and the problem is not resolved I would wonder what exactly I paid for... Here is what I would do. 1. Run the glass plate program. This will eliminate variables in your production parts and boards. Additi
Electronics Forum | Thu Feb 02 20:48:07 EST 2006 | ____
I would like to start a new post regarding fuji > NXT machine. What do you think about the machine > as far as the servicing of the machine goes. I am > so used to the older machines such as : CP,IP, > and QP. Those machines at least give you som
Electronics Forum | Wed Jun 09 10:41:28 EDT 2010 | chrislyttle
We've been having some problems with out Fuji IP2E machine that we've recently bought from a company that is no longer operating here. Since installing it we've encountered a few problems with it starting up. To give you a quick breakdown of its be
Electronics Forum | Sat Jan 20 17:41:11 EST 2007 | bvdb
Hoping someone can help us. Our Fuji IP-1 won't boot up unless we disconnect the 25 pin RS232 connector that runs to the MCS16/F programming computer. It doesn't matter if the 9 pin connector on the other end of the cable is plugged into the MCS16/
Electronics Forum | Sat Aug 22 10:25:11 EDT 1998 | Ben Salisbury
| We are using PCBs of CEM3 Material with bare copper fiducials. The whole | board is of bare copper with a lacquer coating (Coats brother S2974). | The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as | well as Fuji CP4-3. In bo
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Career Center | Fredericksburg, Virginia USA | Engineering,Maintenance,Management,Production,Quality Control
• Certified CP643 Loader Calibration – FUJI American Chicago, IL 2001. • Certified - Cookson Performance Solutions BTU - PARAGON - P150 Oven – Maintenance & Electrical Troubleshooting Charlotte, NC 2001. • Certified UNIVERSAL (GSM) Platform: Operat