Electronics Forum | Fri Jul 24 17:28:57 EDT 2020 | rsatmech
Hello all, We have a new model running upon analysis I found one challenge while cleaning the send side boards. We have a thru hole in top where it's bottom ends are covered inside the shield. Operator find difficult to clean as it has high chanc
Electronics Forum | Thu Aug 27 16:39:37 EDT 2020 | aurash
I opened a case on the JUKI support in Germany and I got some help but we are in the same spot like a week ago. I have 30 years of industrial automation expertise I checked everything I've been told to check - searching trough detailed logs and send
Electronics Forum | Wed Aug 26 15:00:08 EDT 2020 | jmelson
That's a rev 1 board, my machine has a rev 2. I have no idea if they are interchangeable. So, I bought a Rev 2 board from Korea. But, I'm flying pretty blind on this. I have traced the ready button signal to a microprocessor pin on the IO_DPRAM bo
Electronics Forum | Sat Sep 12 02:16:41 EDT 2020 | jmelson
Arrgh, that's an SFA-410ED camera, original subject was wrong. Hello, the down camera on my Quad QSA-30 has gone haywire. It still puts out video, but does not sync to the vision system, the picture rolls horizontally. I have verified the vision int
Electronics Forum | Fri Oct 23 12:06:50 EDT 2020 | johndep7
We may have resolved this issue (fingers crossed) We had someone come out and they informed us that our refractometer was broken. Our measurement of 13% was actually closer to 18-20%. Since making the adjustments our solder has been running much clea
Electronics Forum | Wed Oct 21 00:37:36 EDT 2020 | gabriel1blue
Has anyone been able to replace or upgrade the floppy drive for this old machines? I tried floppy drive emulator but have not been able to make it work. Floppy drive are old and have many problems anyway and would prefer to change it to something new
Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Sat Oct 24 10:41:40 EDT 2020 | phomann
Hi, This error popped up while running a panel through the machine. I put the machine into the Drift adjust mode and the y axis was drifting, but not smoothly like the X-Axis was. The Y-axis was drifting but not smoothly. It was more of a jerking mot
Electronics Forum | Tue Dec 01 15:32:27 EST 2020 | spoiltforchoice
Could be your graphics card driver is set to output a resolution/refresh rate not supported by either monitor you tried. In that case XPs "Safe Mode" should use safe defaults just like it is doing when you see the loading bar. Another option is someh
Electronics Forum | Wed Dec 02 10:00:17 EST 2020 | spoiltforchoice
That STOP error code does google. It would suggest an incomplete or corrupted windows installation. if safe mode doesn't work its very unlikely normal mode is. Sadly fixing XP issues is much harder than it is these days with Win10 which has repair fu