Electronics Forum | Fri Nov 24 07:18:38 EST 2006 | Friend
Perhaps this message in the fine SMTnet archives can help: http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=582&
Electronics Forum | Tue Nov 28 17:13:38 EST 2006 | ebert
Hi Lou, If real process control and useful defect data is what you're looking for, Orbotech has some of the best tools available out there.
Electronics Forum | Thu Dec 07 18:13:13 EST 2006 | russ
Just had anopther thought, what type of parts are you using on this board? You may want to try a thin stencil like 5 mil or so this may help you. also can this "tilt" be from a movement during reflow? Russ
Electronics Forum | Fri Dec 08 11:30:19 EST 2006 | ganoi
We discussed about applying 2 dots of glue on either sides of the LED body, but have yet to try it out. Other discussions include conductive adhesive, using fixturing with weight, different stencil aperature design, hand soldering.
Electronics Forum | Fri Dec 08 11:56:23 EST 2006 | russ
Wouldn;t the glue hold the part up?, usually a glued part has much higher standoff than a soldered one. Russ
Electronics Forum | Fri Dec 08 12:13:22 EST 2006 | ganoi
Sure would. We discussed applying the glue on the sides rather bottom of the part. Hopefully the seating of the part during P&P helps push it down. Certainly there will be still some gap as some of the glue will be under the part. Each experiment off
Electronics Forum | Fri Jan 19 07:21:07 EST 2007 | meritajs
Thank all for your advices. But we had sistem error,which was connected,how we could undestand with failure main PC controller boards.We had swoped winchester memory block and Zevatech operation was restored Best regards Peter
Electronics Forum | Mon Jan 15 19:21:08 EST 2007 | SWAG
Not sure if this has any bearing on the problem but did you check to see that T2 and T3 are jumped on the speed control board per the first note in the prodedure?
Electronics Forum | Thu Jan 25 12:50:45 EST 2007 | stepheniii
What about the relay that controls the heater? I've seen that problem on conceptronics ovens. The relay would latch on and never turn off.
Electronics Forum | Mon Feb 12 15:32:10 EST 2007 | davef
stepheniii Unsure how they determine that the process is stable and in control, a prerequisite to calculating Cp, Cpk. A trained chimp smoking a cigar could calculate Cp, Cpk.