Electronics Forum | Mon Oct 22 08:27:49 EDT 2018 | filipblad
Hi, We're having issues with our mydata tp9 pick'n place. It doesn't go all the way down on the tool, so it can't pick it up or install it. The fault code I get when trying to install tools is F-TLMN-18: Can't reach tool bank. Any ideas? I've comp
Electronics Forum | Mon Dec 31 11:19:32 EST 2018 | robertbronx
We have in our Co. an used My Data SMT (Version 2.5.4d) machine but we have a problem. After creating the file we import with a flash drive.We load and set the two fiducials and after everything is done we try to EXPORT the PCB file instead of being
Electronics Forum | Sun Feb 24 11:16:12 EST 2019 | proy
Guys, I have been down this road also spent a lot of time working on this. Electrolytics often are difficult to solder like this. For the sake of testing, try a water soluble more active flux as an initial test. IF you compare hand solder wetting the
Electronics Forum | Fri Mar 08 04:03:34 EST 2019 | alexcouto
Hello guys, I am not very familiar with samsung cp 45 neo machines, however, I am trying to repair a head that from what I was told was always disabled. I activated head # 6 and there was no movement in the first phase, I thought it might be the fail
Electronics Forum | Thu Apr 04 12:52:48 EDT 2019 | rodrigo
Hi, Our MCS30 had a bad backup battery in one of the boards. After changing the battery I got the all boot devices failed error. I managed to get a hold of some boot floppy disks and I can use disk1 to boot the MCS30 to a "$" prompt. I also have a di
Electronics Forum | Mon Apr 29 12:45:00 EDT 2019 | slthomas
When you say "....is there a way to easily (or at all) reference parts with the same specs..." do you mean when ordering stencils, or are you trying to drive your designers to choose a package that you already have in play when they have package opti
Electronics Forum | Thu May 02 13:40:25 EDT 2019 | youngbuck
Hello All, I am having a issue with Siplace 80 F5 with parts placing of in the X direction after I do Zero Point Correction with tool and Full Calibration. I also do the Gantry Zero Point correction and parts still place off in the X about .200mm to
Electronics Forum | Tue May 21 15:36:22 EDT 2019 | gregoireg
Thanks to @davef and @Evtimov for trying to help. It's useful but not exactly the answers I would like to get. I'm going to reformulate my question. I'm writing in mm so that it's more precise: I have a 0.12mm-thick stencil for some 0.4mm-pitch QFN
Electronics Forum | Sat Jun 29 04:11:31 EDT 2019 | jackson_jade4
Well, I know that this is not directly related to the pycom device, but the code and load cell are connected to the device so I am hoping to gain from the wealth of knowledge and experience on this forum. Until a few weeks ago, I knew nothing at all
Electronics Forum | Tue Jul 23 18:19:30 EDT 2019 | slthomas
It depends on what you mean by "going from....to....". If I just decided that I wanted to try a Type 4 paste on something that I'd been having problems printing, I'd probably just grab one (edited to add that we have a couple of re