Electronics Forum | Wed Jul 15 14:06:37 EDT 2009 | chrisgt
Hey Dax. I bought a Dr. Storage dry with Nitrogen Generator for my components. It worked out great. Haven’t really had any serious problems it just took a few hours to get the humidity I wanted it at. I bought it from Manncorp. I think they normally
Electronics Forum | Wed Jul 08 00:16:30 EDT 2009 | magnifico
Hi Daxman I have the F4G installed in a host PC. I would like a summarized procedure (e.g. step 1, step 2, etc)on how to program, as reading from the manual is taking time. This could get me started faster. Appreciate any inputs. Thanks
Electronics Forum | Thu Jul 09 04:15:50 EDT 2009 | dj_jago
$1000 each and once the pad has turned 'black it is almost impossible to re-tin it. Has anyone else seen this problem? Do we have any comeback on our suppliers do you think, given that we placed the components onto the boards and subsequently remove
Electronics Forum | Mon Jul 20 06:46:50 EDT 2009 | brucow
Hi All, If anyone knows the default password to enter the BIOS on the Philips Comet 1 machines it would be much appreciated if you could post it here. I am trying to replace the hard drive in our machine with a standard 4GB unit formatted to 40Mb bu
Electronics Forum | Fri Jul 31 12:53:58 EDT 2009 | dyoungquist
On our Mydata machine, we place a piece of scrap bare pcb next to the pcb we are loading. Using double sided tape, we attach the cut tape strip to the bare pcb, then program the machine to pick up the parts from that location. The smallest Mydata m
Electronics Forum | Fri Aug 07 15:56:56 EDT 2009 | davef
Well, since you've gotten no takers, we'll launch in to this with careful analysis and introspection, fully aware that we're likely to get 'blasted' for any number of reasons. The most critical parameters to monitor for proper wave solder machine pr
Electronics Forum | Tue Aug 04 03:54:04 EDT 2009 | rafacadiz
I would like to perform a Solder paste height capability study. I will apreciate any info about and what equipment use to measure the height of the solder paste. I only found the attached equipment. Solder Paste Height Measurement System (SPM-300-3D
Electronics Forum | Thu Aug 06 17:56:29 EDT 2009 | stevea
Don't forget about ASC International. Having the largest supported installed base of benchtop SPI systems in the world, I'm surprised we were missed. If you have any further questions, I woudl be happy to assist. We have performed hundreds of test
Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Fri Aug 07 13:29:53 EDT 2009 | cadone
Hi, We are designing a PCB where I need a Low height wire to board connector at the edge. I am looking for a 2 wire female surface mount connector that is not taller than 2.5mm Can any one here suggest me a place I can find this. Thanks CADone