Electronics Forum | Thu Dec 16 10:08:20 EST 2004 | jdengler
Hi Clayton, If your in the USA you should contact Fuji America for new manuals. I bought some a couple of years ago for $35.00 ea. That's a bargain in this industry! Used manuals often have missing or damaged pages. These always seem to be the o
Electronics Forum | Mon Mar 28 18:05:13 EST 2005 | darby
The Yamaha manual is pretty straight forward on this one so I presume the "Philips" is as well. Go to the Maintenance, Repair and Adjustment chapter and look up Drift-Adjusting. It is in the Controller section. If you don't have a manual let us know
Electronics Forum | Mon Sep 12 14:38:56 EDT 2005 | patrickbruneel
Amol, Your problem is already very isolated only one part has the problem (the part that is hand soldered) Manual cleaning is very difficult. Why are you not considering a no-clean cored solder to solder the one part and skip the manual cleaning. Do
Electronics Forum | Mon Oct 03 09:19:10 EDT 2005 | John S.
We've been using Horizon 01's for a couple of years. We use the advanced 2d board and stencil to setup process control through QC-Calc. It works very well, but you must put the time into setting it up. Ask DEK if they can get you a manual for thei
Electronics Forum | Fri Oct 07 15:49:58 EDT 2005 | Amol
Hi, Can anyone suggest what solvents are the best for manual stencil cleaning?? we are currently using alcohol wipes, but the fine pitch apertures still have solder paste stuck in between them. We should ideallyhave a stencil cleaner, but until that
Electronics Forum | Sun Mar 26 12:04:41 EST 2006 | fastek
Mike- Send me the part number from the manual. I carry a lot of PFA spares. If this motor is used on other PFA models I might have it....but I need more info. If you don't have the manual then forward the detail from the motor itself and send me a
Electronics Forum | Wed Jan 24 09:57:35 EST 2007 | Joe
a customer of mine purchased one of these units. didn't come with manuals, called austin american they want 5k to register so they can buy manuals. does anyone have a copy that my customer could either pay them to scan or copy. Much thanks!
Electronics Forum | Mon Jun 11 09:15:46 EDT 2007 | rgduval
Steve, I'm trying to. I don't like the manual printing, in general...it works for us with short runs, etc...but, in general, I don't like the non-repeatability of manual printing. If the right deal comes up, I may be able to justify it. In that c
Electronics Forum | Thu Jul 19 14:03:53 EDT 2007 | slthomas
Radial Leads (I've had IIs, IIIs, and Vs) do the job nicely, but they need weekly maintenance to keep them running. I don't know if you can get parts for them or not if you're not registered with UIC, but you WILL need parts for it. You will need al
Electronics Forum | Thu Oct 04 20:50:45 EDT 2007 | itaig1
We recently purchased an IBL VPP-M600 vapour phase reflow oven. We currently only have partial documentation and need to know the requirements for the water cooling. ie flow rate, cooling power etc. We also need the spare parts listing and service ma