Electronics Forum | Thu Feb 11 06:50:17 EST 2010 | CL
Good Morning Bryan, We are using Mirtec MV-3 AOI's with 4 megapixle cameras. We use them for 100% post reflow. We are checking, presence, polarity, value, solder, bridging,component height for BGA, QFN etc... and 1st piece validation for machine set
Electronics Forum | Thu Feb 25 07:28:16 EST 2010 | pcbrown
I have programmed and used both. The IVC is just an upgraded model of the IIC. They both work the same, same sofware, feeders, etc. The IVC just has more bells and whistles. I'm not sure what the differences are but I would opt for the IVC because I
Electronics Forum | Wed Aug 11 06:40:51 EDT 2010 | bob
If the fiducials are bad. There are 2 lights on the downward camera. The one that you can see is mainly used for bright and shiny fids....the other light is for dark/dirty fids. Turn this light on and set the other for 1 (not 0 because of a software
Electronics Forum | Fri Sep 03 03:49:24 EDT 2010 | sachu_70
In case of pure pattern recognition, i agree with your view. However, the basic functionality of the fiducial is determine any positional offset of the PCB and provide necessary data for correction during the intended operation such as Paste printing
Electronics Forum | Fri Aug 27 14:41:36 EDT 2010 | namruht
The machine sees the nozzles and thinks that the part is there. The lighting on the machine is in desperate need of an upgrade. Constently having to tweak the GF's to get components to pass vision. We share a line computer between 2 lines and the cam
Electronics Forum | Fri Jan 07 12:26:02 EST 2011 | seshadri
Dear friends, I would like to have your comment on Vitech and Mirtec. We have used Vi - 5K Perform in our facility and we have been requested by our customer to have AOI with side angle camera for the automotive board inspection for a up coming proj
Electronics Forum | Mon Feb 14 05:58:06 EST 2011 | vinitverma
Gabe, You now need to teach the Datum position for the front feederbar and for the rear feederbar too. If I'm not mistaken the datum position for the front feederbar is position no. 21. Just put a feeder on position no. 21 and use the camera to find
Electronics Forum | Fri Apr 01 18:32:51 EDT 2011 | frcdave
Dback, Some questions for you: 1. Are you using the red light configuration for better contrast on the 0402 parts? 2. Is your system fitted with both low and High Magnification cameras? Have you spoken with the guys at YESTech? Their phone support i
Electronics Forum | Tue Jan 03 14:35:40 EST 2012 | comando
Yes I have this tools and jigs but I can't to complete first calibation (Image camera Y Adjustment) I done all and the nozzle is in the center of display but the machine don't perform this calibration. the nozzle image in display look litle big than
Electronics Forum | Wed Dec 14 08:46:58 EST 2011 | cbroegger
Hi, we use some camera based readers, they can scan all barcodes in a square of roughly 10 x 10 inches. We have some pcbs with 3-4 barcodes (linear, 2D barcodes), and it can read them all in one take. I can find more information if you need that.
