Electronics Forum | Thu Oct 26 11:17:09 EDT 2023 | sarason
The Philips CSM84 is also known as the Yamaha YM84 John Melson (jmelson) is an expert on these machines , he lives in the US. He is often active on EEVBlog and has been active on SMTNET in the past, asking many questions on this machine. My p
Electronics Forum | Wed Nov 08 20:22:13 EST 2000 | Dave F
You need to remove the oxide before you can properly solder your [or any] component. Call your flux supplier ask them for a more active flux than you are using and for their recommendations on removing the flux residues.
Electronics Forum | Fri Oct 13 15:46:43 EDT 2000 | zorox
You are not unique. We too are using "no-clean" flux but yet we still have to use flux off to clean the boards before our test bays. I know of no solution to this yet but I am actively seeking one.
Electronics Forum | Sun Aug 27 11:37:28 EDT 2000 | RJ
If you have another container of flux that is a different batch try that. Dont forget to clear lines of old flux. check spray pattern width. The activators needed may be dead in flux.Since it is sudden my question would be what just changed?
Electronics Forum | Mon Aug 21 11:28:30 EDT 2000 | James
Question: Do you run your pallets hot or cold thru the wave? I ask this because if you run your pallets cold the board will never preheat to the correct temp. thus, your flux won't activate properly. James
Electronics Forum | Fri Jun 30 11:33:04 EDT 2000 | Walter
CAL Comp 34180 DIGITIZER Installation on MYDATA TP-11UFP Installed per set-up & installstion documents provided by CAL Comp. When trying to activate mouse get no result.
Electronics Forum | Wed Oct 10 12:22:08 EDT 2001 | Kevin
Cal, There are several suppliers of cover tape materials that do not require heat to activate the adhesive. 3M and Advantek are likely the leaders. There are relatively few T&R machines that can handle both heat and non-heat applications - as Chri
Electronics Forum | Sat Mar 18 07:43:25 EST 2000 | Dave F
Larry: I'd like to see your angle increased generally and that could fix your problem. Lots of other things can cause skips, such as: * Wave height, your might be high with 2" of contact * Flux contamination, activity * Component contamination * C
Electronics Forum | Thu Apr 19 17:27:18 EDT 2001 | raton
Activators get jiggy wit flux????? Dave, Could you define 'jiggy' for those of us who are among the culturally challenged? Boca
Electronics Forum | Thu Aug 24 08:59:38 EDT 2000 | Eugene Smelik
Dr. Lee, For Pb-free solders, will the reflow profile be similar to that of Sn/Pb, with an flux activation plateau before going to peak reflow, or will the profile be more linear in nature? Are there advantages/disadvantages to either profile for P