Electronics Forum | Tue May 31 15:29:09 EDT 2011 | leemeyer
I have a QSP-2 which I assume is in the same family as the QSA-30. I compared the diagram that is in the service manual with a board from a 2-C and they appear to be the same. Your best bet would be to contact PPM at http://www.goppm.com. They shoul
Electronics Forum | Wed Sep 26 14:18:50 EDT 2012 | tank
Wondering how good the software is for the Quad QSA 30 is. Is it a pain to program? We have panels with 100 boards... 1500 parts, I hope you don't have to manually teach the whole panelized board. Any other info you can provide is welcome. We
Electronics Forum | Thu Feb 26 12:58:21 EST 2015 | daniel_esposito
Hi everyone! I have P&P Quad IVc. The Hand Held Terminal (HHT)says "V idle" intead of "V ENTER CMD", and when it is running, the HHT shows commands lines each one at the same time it is running. One of our technician entered mistakenly, at the HHT,
Electronics Forum | Mon Jul 10 09:28:25 EDT 2006 | Bobpan
Have you tried turning the theta manually to feel if it is stiff or having a harder time turning. This will cause Quadalign errors. also be sure the handling is not set to 10% on the theta this is also a problem.
Electronics Forum | Tue Mar 11 09:21:40 EDT 2008 | leemeyer
I have a spare copy that I can send to you. This is a DOS based program. Send me your email so that I can contact you about this.
Electronics Forum | Wed Oct 08 12:49:37 EDT 2008 | leemeyer
When in the fiducial teach screen check to see if the "Fiducial Data from Autoprogram" box is checked. If this program was not generated from Autoprogram this box should not be checked.
Electronics Forum | Wed Oct 08 13:30:04 EDT 2008 | bobpan
You need to check and see what you have 'y' set to in teach fiducials. Make sure you have only 1 with a 'y'(panel or multi-image fids)....then teach the appropriate one.
Electronics Forum | Wed Oct 08 14:20:34 EDT 2008 | sambolian
I only have 'Y' in the "Global Fiducial Correction" box , but it still gives me the error of "Fiducials not taught". Any more suggestions?
Electronics Forum | Wed Oct 08 14:30:42 EDT 2008 | leemeyer
Was the board programmed using Autoprogram or did you hand program it? What version of Central Controller are you running.
Electronics Forum | Wed Oct 08 15:46:41 EDT 2008 | bobpan
ok....couple of other questions first......does your machine say MVS when entering into central controller? After you teach your fiducials...Are you entering out of the screen....if you hit escape it doesnt save what you have done.