Electronics Forum | Tue Mar 26 07:42:32 EDT 2019 | kylehunter
Hello all, My company specializes in pcb design and subsequent prototype assembly. With that core of business, we will assemble up to 10 boards a week. We currently hand solder and use a reflow hotplate for these boards. We have been getting reques
Electronics Forum | Mon Apr 15 10:03:39 EDT 2019 | kylehunter
Ahh that makes a lot of sense. All the boards I will be doing for the next while will be leaded, so I think I'll start with the 1500, and then worst case upgrade later if needed.
Electronics Forum | Thu Apr 25 10:00:25 EDT 2019 | SMTA-Gregory
I would suggest you look a the Sikama International Falcon 5 benchtop reflow system, Economical, reliable and good value. You may be able to get one on the used equipment market.
Electronics Forum | Tue Mar 26 10:30:28 EDT 2019 | pavel_murtishev
Hello, Could you please tell me if there is any industry standard specifying QFN to PCB standoff after soldering? Is any gap allowed? Browsing IPC-A-610, I have found nothing. Any input would be appreciated. Regards
Electronics Forum | Tue Apr 02 10:02:39 EDT 2019 | lapskrfc
Thanks a lot for your reply and the useful information you provided. By any chance, have you heard anything about the Finetech CorePlus?
Electronics Forum | Thu Apr 04 07:10:44 EDT 2019 | robl
Hi Matt, We've used the MX-5210 version, and they are good irons. Regarding the cross-breeding with a Christmas tree, we're not sold. Rob.
Electronics Forum | Fri Jun 07 10:46:16 EDT 2019 | gregoryyork
The Single Solder ball stuck to the mask may indicate undercured as well. The issue is not so much the mild No Clean flux but the potentially major active HASL flux or Silver Process chemistries causing issues. This has been through flow solder hasnt
Electronics Forum | Wed Apr 10 17:15:26 EDT 2019 | davef
Here's a good summary: https://www.fda.gov/downloads/Drugs/DevelopmentApprovalProcess/SmallBusinessAssistance/UCM466496.pdf
Electronics Forum | Mon Apr 15 12:10:00 EDT 2019 | slthomas
"To qualify the equipment for production use, you need to only do IQ, OQ." Even in a scenario where you're installing a piece of duplicate equipment, how do you demonstrate (and record) that the new machine provides acceptable product?
Electronics Forum | Wed Apr 10 05:29:08 EDT 2019 | SMTA-Tiberius
Hi there , We just got a 2000 litre Nitrogen tank for our Heller1809MKIII Reflow Oven , it has been installed and calibrated last week but now the Oxigen PPM doesn't drop below 3000 . Did anybody dealt with this issue before ?