Electronics Forum | Wed Sep 01 19:35:41 EDT 1999 | KEVIN SIMPSON
| To All, | | Since Tuesday morning (EST) the SMTnet site database has been upgraded from MS Access to MS SQL. This should help reduce download time and improve our ability to handle the increasing site traffic. Have any of you noticed a change in
Electronics Forum | Thu Sep 02 08:00:32 EDT 1999 | Doug Philbrick
| To All, | | Since Tuesday morning (EST) the SMTnet site database has been upgraded from MS Access to MS SQL. This should help reduce download time and improve our ability to handle the increasing site traffic. Have any of you noticed a change in
Electronics Forum | Wed Sep 01 12:26:32 EDT 1999 | Jae Hinson
To aid in heat dissipation of our PCB, we would like to try having copper fill areas on the board that are hot air levelled and not covered with solder resist. Then, when the board is reflowed, solder paste would be applied and then solder. Has anyon
Electronics Forum | Sat Aug 28 09:47:29 EDT 1999 | Mike McMonagle
Just a brief missive, wondering who will be attending SMTA International in San Jose on September 12-16. If you are planning on being there, drop me a line off SMTnet (to minimize the 'idle chatter') and let me know when you will be there. It would b
Electronics Forum | Wed Sep 01 13:44:42 EDT 1999 | Dave F
| Recently, our solder dross reclaimer refused to take our | used solder paste tubes. He said the small percent of paste | remaining in the tube is now considered hazardous waste. I'm interested in advice on how others are disposing of this "hazardou
Electronics Forum | Sat Aug 28 09:23:36 EDT 1999 | Mike McMonagle
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Check out the EasyBraid website below, they carry IPC standard coupons, flux test kits and SIR meters at reasonable prices.
Electronics Forum | Wed Sep 01 14:23:04 EDT 1999 | Dave F
| Has anybody run across a good concise book or other source on solder paste, its characteristics, handling, storage, stencil design, printing and reflow? Yes I asking for the world! | | TX | Mark | Mark: Jennie Hwang, a sometimes SMTnet visitor,
Electronics Forum | Mon Aug 16 05:09:30 EDT 1999 | Charles Stringer
Atlthough not strictly surface mount, I am sure that amongst the experienced players out there someone will have some answers for me. Does anyone have any experience of "phase change" heatsink materials. These are solid at room temperature and then t
Electronics Forum | Thu Aug 12 17:07:09 EDT 1999 | Brian Wycoff
| Hello, | | Can any netters suggest what critical parameters should be considered & what are there assoicated impacts for a solder paste printing process ... | | B.Regards, | Felix | I have a process cause and effect diagram for the entire print
Electronics Forum | Mon Aug 09 20:12:24 EDT 1999 | JohnW
Folk's, I'm looking for some helpful suggestions for reworking wave soldered bottomside components that have been glued. I'm not a fan of the twist and break approach and as some of them either have a double dot or a slot configuration this tend's t
