Electronics Forum | Mon May 04 21:54:14 EDT 1998 | Dave F
| I've never seen this before. Today, I got this tombstoning on Tantalum Capacitors (Okay, I saw that before) | Here's the part that seems weird to me: | -They didn't tombstone onto a termination - they went onto their sides! That's right, both ter
Electronics Forum | Fri May 01 22:05:23 EDT 1998 | D.Lange
| I've never seen this before. Today, I got this tombstoning on Tantalum Capacitors (Okay, I saw that before) | Here's the part that seems weird to me: | -They didn't tombstone onto a termination - they went onto their sides! That's right, both ter
Electronics Forum | Fri May 01 14:44:26 EDT 1998 | Earl Moon
| I've never seen this before. Today, I got this tombstoning on Tantalum Capacitors (Okay, I saw that before) | Here's the part that seems weird to me: | -They didn't tombstone onto a termination - they went onto their sides! That's right, both ter
Electronics Forum | Fri Apr 17 21:34:02 EDT 1998 | D.Lange
| Hello Ya'll, | I've got what may be a silly question, but why does it seem so important to everybody that you have x-ray capability if you're thinking about doing BGA? | I know what most people will tell me; "Steve, that's a pretty silly qu
Electronics Forum | Wed Apr 08 15:47:07 EDT 1998 | Ron Beasley
| | Any one have any experience with or knowledge of the Panasonic HDP-G1 adhesive dispenser, or any other Panasonic dispensers. | Ron, | I have used this piece of equipment and I'll tell you what I tell everybody else about it. I don't trust it. T
Electronics Forum | Tue Jul 19 09:06:00 EDT 2016 | davef
We used to use those, back in the bad old times. basically, it's a router with a blade on it that is used to trim the leads of PTH components that are mounted on boards. Nasty process. Difficult to control. Messy, firing cut leads all over the plac
Electronics Forum | Tue May 02 14:19:26 EDT 2000 | Bill Schreiber
There are two primary causes of epoxy adhesive bond failure, heat and over exposure to moisture. Ultrasonic cavitation is a only a mechanical "scrubbing" action on a microscopic level. However, if the adhesive bond is week or has small areas of det
Electronics Forum | Wed Feb 17 15:56:22 EST 1999 | Tuffty
| Dear Al, | Are these reworked, double-sided boards? | | If you attempt to clean side #2 of double-sided misprint in a "spray" type cleaner, millions of solder balls can be broadcast throughout the same chamber as the populated side #1. Or, if thi
Electronics Forum | Mon Aug 29 17:59:24 EDT 2011 | garryc
My first printer was a Speed Print machine back in 2001. We still have it as a backup. I needed a printer quickly so I bought an EKRA from a show. We were very disappointed with that machine. The service was terrible. Parts were impossible to get. I
Electronics Forum | Fri Jun 09 07:56:25 EDT 2017 | prdmm1
our company has just purchased the MC110 High-Accuracy Manual Stencil Printer. the only thing I'm not sure about is how to use the PCB Edge Stopper. how is this used? the groove with the stoppers on it is too deep to hold a board because it would s
