Electronics Forum | Mon Oct 21 15:14:53 EDT 2019 | compit
As you can see in machine B on pins 1-2, the circuit closes - give the button / contact here. The voltage you provide most likely applies to pins 3-4. In my (and in the SMEMA standard) it looks like this:
Electronics Forum | Wed Oct 30 13:43:17 EDT 2019 | emeto
This should be fixed by someone who has access to Windows on these machines - probably ASM engineer. You are right to be worried about traceability. Also changing this time might lead to much more issues underneath, so don't just change it before ask
Electronics Forum | Mon Mar 16 14:58:22 EDT 2020 | tnachamp
Thank you for the response. It is strange that the TTG & BTG option is available on our other DEK but is not in this particular DEK. Both machines have the same software and version.
Electronics Forum | Wed Nov 06 08:23:53 EST 2019 | dekhead
If it is always showing 5.0Kg as the "target" value on the error on the first print then yes there is a problem. Are you certain that it is accomplishing the requested (12Kg ?) on the prints thereafter? Does it do Heights calibration (no tools requir
Electronics Forum | Sun Nov 24 12:44:10 EST 2019 | bane016
I have problem with feeder cart.I have no voltage on any of the 17 feeder connectors, and when i insert the cart in the machine i get the message that the cart is not connected. I have a voltage to one separate connector normally.
Electronics Forum | Fri Nov 29 14:45:36 EST 2019 | csm
Dear Alexey I appreciatte your comments and suggestions, we have some old machines and we will replace some of them but unfortunatelly budget is limited. We say videos where we can see the GC-60D working and it looks good. Regards
Electronics Forum | Mon Dec 02 13:53:19 EST 2019 | alexeyzb
Old GC-60D is risk of failure. So Juki is more easy for repairment. For example juki has one calibration jig for head with machine but for GC-60D head you need very expensive KIT (or you need to buy service).
Electronics Forum | Thu Dec 12 03:57:57 EST 2019 | winston87
Hello , I would like to know if anyone has electrical schematics on the DEK 288 machine. Thank you
Electronics Forum | Mon Dec 16 04:26:28 EST 2019 | fidra
Hello, we have problem to install software on new hard drive, old one lost some files and can not be repaired by NT4.0 repair procedure. We have floppy with program and setup files for this machine. Thanks in advance
Electronics Forum | Thu Dec 19 17:13:02 EST 2019 | kylehunter
So how'd you do it? Each machine has a separate hole? Or all piped to one?
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477