Electronics Forum | Thu Feb 24 12:08:13 EST 2000 | JAX
Mark, This topic has been discussed multiple time on this site. You can find almost all of them by searching the archives for tombstoning. That aside, have you look at your stencil apetures?(homeplate design).
Electronics Forum | Wed Jun 07 16:34:09 EDT 2000 | CJ Bonifas
Are there any other manual reballing systems aside from the one made by Hepco that use a vacuum method for ball placement?
Electronics Forum | Mon Jul 06 18:52:10 EDT 1998 | Dave F
Aside from process flows where the next step is: 1 Powering-up an assembly 2 Testing the assembly on electronic test equipment Is there a reason (need) to dry assemblies after water washing followed by a DI water rinse? Or is air drying OK? Dave F
Electronics Forum | Wed Sep 25 13:38:35 EDT 2002 | finepitch
Yannick, If we leave the 201 issue aside; have you checked where those BGA pads are connected to? Could those be power/ground balls connected to large (difficult to heat up) planes by any chance? Erhan
Electronics Forum | Wed Sep 18 18:10:15 EDT 2002 | davef
IMHO, this finish is more cosmetically appealing than technically desirable (and VERY profitable for the PCB maker). That editorial comment aside, you're correct. Increasing the concentration of gold: * Hardens the solder. * Increases the liquidou
Electronics Forum | Fri Aug 22 07:04:39 EDT 2003 | jdumont
What is the difference between a solder gun and iron, aside from the obvious physical ones. Do guns have the ability to supply heat at a faster rate than an iron?? Thanks for the posts everyone.
Electronics Forum | Tue Sep 21 14:11:03 EDT 2004 | Dreamsniper
Hi, Is there a company that provides training for the BGA X-Ray Inspection Criteria? Or where can I find articles or any docs about this aside from IPC 7095? regards, Dreamsniper
Electronics Forum | Thu Apr 14 11:03:51 EDT 2005 | patrickbruneel
All possible causes aside, how can a dead short pass your ICT unless the connector is not probed.
Electronics Forum | Wed Jun 08 14:04:50 EDT 2005 | cyber_wolf
If you are facing the back of the machine take left most panel off. There are usually two fans built into this panel.(unplug the fan connector and set cover aside) The servo-driver cards will all be in a row. They should be labeled accordingly.
Electronics Forum | Mon Jul 18 09:43:31 EDT 2005 | norrin_radd
Aside from a visual first article to IPC 610, what inspection criteria do people put in place post wave solder (pre clean)? Thank you