Electronics Forum | Mon Dec 05 09:04:25 EST 2011 | haiae
I just buy a used Contact 3AV machine. Afer fixed some things I think the machine can be ready to run and in fact for first time the machine power up, pass all self testing, homing is done, moving of table, heads, actuator is good, pneumatic function
Electronics Forum | Wed Jul 04 09:58:50 EDT 2012 | daxman
Assuming that you have a saturated moisture-sensitive component: At what temperature would popcorning or internal component damage occur? I would guess that it would be at a temperature where water would boil, around 100 degrees? However, the JEDEC J
Electronics Forum | Sat Sep 29 02:58:18 EDT 2012 | ericrr
I tried to look for "H890" on Internet and went nuts, (Thanks to Google) I would think H890 is part of a diode manufacturer part number. Have you tested it for a diode function? or maybe you have this is why you want a replacement. Tantalum capacito
Electronics Forum | Mon Aug 05 22:10:38 EDT 2013 | jaimebc
We have HRFT-301U ( staple bend) is fairly easy to set up. All you need is t-handle Allen that I believe is provided with the machine. All adjustments to form a part, both pitch and lead length are mechanically adjusted by sliding the forming and c
Electronics Forum | Thu Sep 12 20:17:59 EDT 2013 | action_101
Good ole contact cs-400. I worked at two different companies that had these machines, all I believe were E's except 1 C. One place had one and the other place had 4 of them. Dont take this personally, but thank god my current employer doesn't have a
Electronics Forum | Wed Feb 05 08:51:13 EST 2014 | emeto
What I think it does is to calibrate the camera. You have your tube on the bottom and your camera on the top. For my machine(Dage) I have to put the board I am going to examine inside and select a point on the board surface. THen I just click on this
Electronics Forum | Sat Sep 26 03:21:58 EDT 2015 | aemery
Mervin, Love these machines, Speedline built about 3500 of them so I have lots to fix. Most issues come down to incorrect use or poor adjustment and alignment. Your description is a little vague, you didn't mention which direction the prints are of
Electronics Forum | Fri Nov 06 07:46:33 EST 2015 | clampron
Good Morning RedChilli, I have worked with Mirtec for quite a few years. I have looked at some of the other machines mentioned but have no practical experience with them. I started with the Mirtec MV-2 (long ago)due to the success of this platform,
Electronics Forum | Tue Apr 19 16:20:05 EDT 2016 | davef
Don't blame it on the poor paste thickness requirement [although I might go on to argue that it's could be a contributor to the issue]. Most likely you're the problem. About 70% of the time solder on gold fingers is caused by poor cleaning of screen
Electronics Forum | Sun Mar 18 20:02:48 EDT 2018 | reckless
Thanks for your help every time! You are right table top units are a joke. For smaller conveyor ovens I found two major brands: Manix (no longer makes ovens) and Manncorp. The manncorp unit I am looking at does not have a bottom heat zone. Mos