Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
Electronics Forum | Sun Mar 04 02:39:27 EST 2012 | eadthem
I don't have our DEK printer part numbers memorized, In general we have a older machine running NT4.0 . It has 2Di inspection but we never use it because you can only inspect/setup 1 camera shot at once, making for very long programming. Our newer D
Electronics Forum | Mon Jan 21 08:26:45 EST 2013 | ngineer
Bobpan, Thanks for the reply. I have been using Tep Vision, I'll see whether I was using GOTO 1 or 0, it may have been 0. I am running from central controller, and am doing a download database from the database utilities when making changes on
Electronics Forum | Wed Mar 21 06:01:07 EDT 2012 | hunzo
Hello Sergey, I have used Kirsten Modula Wave with ADL (anti dross liquid) option. We have had the same expectation like you: less dross and lower operation cost due to no inert gas is required. That is achieved, the dross generation was modest and t
Electronics Forum | Fri Apr 20 14:11:27 EDT 2012 | rway
Programming is different, yes, but so is the terminology. ///with machine vision you have parameters that select what is good and what is bad, and you have parameters that help make bad look worse and good look better making the difference between w
Electronics Forum | Wed Apr 11 00:40:19 EDT 2012 | ngineer
I have a problem setting up the LAE on my Quad 4c. I set it up for 0805, and it seems to work, although it rejects a lot of parts, at least it places "most" of them. I tried setting up on a soic14, and could not get even one to pass. I believe I h
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Sat Apr 21 04:39:45 EDT 2012 | brotakul
I am using different equipements for SPI such as Koh Young and Cyber Optics machines. I am looking for implementing a general procedure (SWP) for setting LSL's and USL's on the products on which the customer does not specify any limits on the solder
Electronics Forum | Tue Apr 24 09:30:43 EDT 2012 | bdamico
Hello Laritzstange, My name is Brian D'Amico, I am the president of MIRTEC USA. I noticed your posting on this forum and I would like to offer some guidance. First, I would like to ask which system you have. Our MV-7 system is an in-line system.
Electronics Forum | Thu May 17 09:01:01 EDT 2012 | scottp
I'm not sure why anyone would pay extra for FG (fine grain) stencils. I've run studies comparing traditional YAG laser, fiber laser, and E-form stencils with regular stainless, FG, and nickel foils. YAG is the worse and should only be used for pret