Electronics Forum | Mon May 02 17:16:02 EDT 2011 | pbiron
We have recently started up a vapor phase machine and no body can tell me what an ideal profile should look like. I preheat the board about 10 degrees lower than the melting point of the solder paste. The joints look great! Just have no documentation
Electronics Forum | Mon May 16 22:06:22 EDT 2011 | danaherr
Downward looking camera not working. swapped cables on board and upward looking camera works when plugged into downward camera's connection on video card. Thinking maybe a cable issue??? manually moved gantry all over trying to see if intermitent ope
Electronics Forum | Wed Jun 01 10:02:56 EDT 2011 | bobpan
Those cards are all different. The c-series stands alone by itself while a qsp2 and qsa-30 mount into a slot. They were all manufactured seperately for each machine. I would purchase a new refurbished one for the 2c machine and forget about the other
Electronics Forum | Thu Jun 02 13:32:05 EDT 2011 | davef
Melanie: We're with AVFOM. If you don't believe there is solder on the pads, use a beer can opener to pop the component off the board and you will have your answer. Easy-peasy. Who ever told you 'if there is solder, there is voids' in solder connect
Electronics Forum | Fri Jun 03 15:19:19 EDT 2011 | jeremymc
After reseating the M controller boards I was able to get further than I had previously, no save status error, and was given an error about the voltage being wrong. During my last run my company had an electrician in to rewire somethings and put a
Electronics Forum | Mon Jun 13 12:58:10 EDT 2011 | deanm
We find it is a bigger issue in the summer when there is more humidity in the air even though our facility is air conditioned. We've also seen similar boards go through the same process and vendor A has problems and vendor B doesn't, so fabrication t
Electronics Forum | Thu Jun 16 20:29:12 EDT 2011 | dman97
Does anyone know if it is possible to change the distance that the squeegees travel? What i mean is... Is it possible to change where the squeegees start and stop during a print? Our squegees seem to stop right at the edge of the apertures and this
Electronics Forum | Mon Jun 27 06:52:07 EDT 2011 | rpatel28364
Hi All We are facing problem with solderability of BGA connector. After Xray we have found open under BGA connector. After removing from PCB it seems some copper pads are still gold. We are not sure why this is happening. We have 5 thou stencil and
Electronics Forum | Fri Jul 08 04:09:59 EDT 2011 | leadthree
I hope to get some feedback here. I have a SMD connector that reflow-solders quite poorly (I guess solder paste or profile issue). On the X-ray I see strange bubbles, does it mean there are voids under pin? Generally I am not satisfied with the sol
Electronics Forum | Mon Aug 22 11:54:59 EDT 2011 | blnorman
A good epoxy should work. Removal would require damaging the board, component, what ever it is attached to. I know Hardman makes a bi-pack ambient cure epoxy that we used in the lab. Search the web for epoxy suppliers, they'll offer various cure s