Electronics Forum | Sat Nov 19 18:35:39 EST 2011 | johndoe0222
We have an old Fuji GSP III-4000 we just changed the fiber sensor on the in-bound and outbound of the printer. The problem we are having now is the board would only go midway the table and it would go up. It does not even reach the main stopper and t
Electronics Forum | Tue Dec 13 17:03:39 EST 2011 | kahrpr
There should not be a problem we have done this. If you are concerned send out a test board to be analysed. we do this about twice a year mostly lead free just to make sure our process is good. the test results are also handy when customers question
Electronics Forum | Thu Jan 19 12:38:03 EST 2012 | cobham1
I am wondering if the failurs that people see are discovered right away or when the units are out in the field. Reason I ask this follow up question is the units that are having problems are all returns from our customers. Is there a way to check for
Electronics Forum | Mon Feb 13 09:34:45 EST 2012 | pr
I am new to the company but the story sounds the same. We have a new board coming in (with CREE LEDS) and I wanted to get in front of it, and found these nozzles. We are going to try them out as soon as we get the spending O.K. They are designed for
Electronics Forum | Thu Mar 08 11:12:44 EST 2012 | eadthem
We just switched to using a paint marker to tag our xouts, and it fixed alot of the problems with using labels(causes over pasting) and using whiteout pens. what were using is the same brand we use in our inspection dept for tagging issues, UniPos
Electronics Forum | Sun Jan 20 17:55:49 EST 2013 | ngineer
Mikej, I'm only running a single image, just want to correct for the slight variations in how the board seats in the transport. It's not more than a few mils off, but enough to cause an issue on fine pitch parts. I don't have any image fiducial
Electronics Forum | Tue Feb 28 07:31:40 EST 2012 | bk
I'm assuming it's your x wagon tranducers that are out of synch. So the first place to start is look at your couplings on both x motors and make sure one of them isn't broken or starting to break. After that i would try swapping out your x board with
Electronics Forum | Thu May 10 15:32:45 EDT 2012 | 14367
We are having a lot of tomb stoning with this no clean solder paste. It's limited to larger, complex boards, affecting 0603 ferrite beads, capacitors and SOT23s. It was suggested that paste removed from a stencil should not be put back in it's origin
Electronics Forum | Wed May 16 09:23:04 EDT 2012 | jeremymek
In my experience Both Dek and speeline machines are good used. personally I think speedline seem to hold up better when PMs have been ignored though. Also make sure you can get a third party board support system into it like a gridlock or Vacunest
Electronics Forum | Tue Dec 18 10:14:14 EST 2012 | moshesh
In those cases where we have a 3.2mm thick, 16-layer board with several GND layers, do we still need ground connection to each and every layer (with thermal relief) or, skip part of the ground patterns? Will it help soldeing rising. I can't reach mor