Electronics Forum | Fri Feb 09 11:48:09 EST 2007 | realchunks
0.25mm tilt? That's pretty small depending on you BGA size. Is it failing? Or just your Q.E. being anal? What size BGA we talking about? What ball count? Just one board? Maybe cheaper to just repair. Now assuming there is NO part under the BGA
Electronics Forum | Fri Jul 13 17:16:49 EDT 2007 | jmelson
I just got a used Philips CSM84 pick and place machine for $1500. I had to widen a doorway and rent a forklift to get it inside, as well as have it shipped. So, the total cost was much higher, but still under $10 K. I may have gotten lucky on this
Electronics Forum | Thu Jun 10 16:42:11 EDT 2010 | daxman
Hi Muarty, We've had a lot of experience with QFN's now. Several years ago we started testing various design methods of the via arrays as well as paste apertures to cover the arrays. There has been some time that has passed now since these packages
Electronics Forum | Tue Dec 04 08:34:07 EST 2007 | davef
We no advice to give you on the topic, but maybe while you're waiting for others to reply, reading a trade journal article on the topic might help. Below is a link to "Pin-in-hole reflow (PIHR) and lead-free solder joints" by David Bernard, Bob Willi
Electronics Forum | Tue Oct 12 22:22:34 EDT 1999 | se
| Hi, | We are in the process of evaluate our solder paste,incoming inspection over the solder paste, stencil requirments: | | 1- Is anybody using/requiring 1000 Kcps or more on viscosity to your solder paste provider ? Why ?? | 2- Is anybody using
Electronics Forum | Mon Nov 29 13:09:12 EST 1999 | Mike Konrad
There are three primary methods of stencil cleaning. � Hand Cleaning � Spray-In-Air Cleaning � Ultrasonic Cleaning Hand Cleaning: Hand cleaning involves the removal of solder paste or adhesives from stencils using a chemically saturated wipe and /
Electronics Forum | Thu Mar 25 09:38:36 EDT 2021 | spoiltforchoice
Well everything Graham said with some additional points.. You mention manual printing but very little about your stencil or setup. Everything you have said indicates a very limited budget has been expended, however what you have is an extreme exampl
Electronics Forum | Wed Feb 13 19:32:02 EST 2008 | daxman
Greetings everyone. We are currently doing some experimentation with solder paste printing over ground planes. In this application, the entire perimeter of the PCB is a ground plane. It's about 4mm wide and wraps around the whole PCB; There is no so
Electronics Forum | Tue Aug 17 10:21:32 EDT 1999 | Steve A
It may be worth mentioning to those that do not have the ability to rotate the PCB, that some folks adjust their aperture design on fine pitch leads by increasing the aperture size for those leads parallel to the X axis, thus allowing consistent volu
Electronics Forum | Tue Sep 07 09:11:33 EDT 1999 | Dave F
| We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes
