Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Hello all,
We have came into this problem that I wanted t...
- Jun 11, 2003
by
Jason Gregory
Hey Jason-
I saw yer post on Technet as well.
First I ag...
- Jun 11, 2003
by
CAL
the registration fee became the second largest issue after 0...
- Jun 11, 2003
by
Stefan Witte
I would like to comment as an employee of a major equipment ...
- Jun 11, 2003
by
GenX
I do not agree. We were even told that if we do not pay, and...
- Jun 11, 2003
by
Jason Gregory
So if I get this right, you have determined the cost of supp...
- Jun 11, 2003
by
terrapinstation
Clearly someone from the equipment side will explain to me w...
- Jun 11, 2003
by
Steve Thomas
Terrapin,
your smugness and decision to "enlighten" us/my...
- Jun 11, 2003
by
Jason Gregory
OK Terrapin,
Here it is, roughly half hour after I vented...
- Jun 11, 2003
by
Jason Gregory
Nobody seemed to notice, when Genrad started to collect lice...
- Jun 12, 2003
by
Stefan Witte
Thank you, Stefan.
I agree with your reply. This coroprat...
- Jun 12, 2003
by
Jason Gregory
Could I get the URL for Technet?
Thanks
James
...
- Jun 12, 2003
by
James
Sure James. It's:
...
- Jun 12, 2003
by
Jason Gregory
Jason,
You state that it is not your job to know much it ...
- Jun 12, 2003
by
Amen Jason-
I have been fortunate and worked on both the Cu...
- Jun 12, 2003
by
CAL
Using the used car analogy...
A used car can be serviced an...
- Jun 12, 2003
by
Again,
I want to pay. I am willing to pay. I just don't t...
- Jun 12, 2003
by
Jason Gregory
The way we do it is $5000 for 1 machine, $500 each additiona...
- Jun 12, 2003
by
Yeah, what Techsuppguy said. But further there are a few mo...
- Jun 12, 2003
by
Yes, I am a customer. I've bought brand new machines from th...
- Jun 12, 2003
by
Jason Gregory
Varied opinions on this thread spread faster than wild-fire....
- Jun 12, 2003
by
Jason
I am an equipment buyer part of my job is to be knowl...
- Jun 12, 2003
by
Scott
Interesting! Several years back I had a through hole machine...
- Jun 13, 2003
by
LarryK
Interesting! Several years back I had a through hole machine...
- Jun 13, 2003
by
LarryK
Larry
Fun, isn't it?!?
Jason
...
- Jun 13, 2003
by
Jason Gregory
Well, I really never understood why. It was a custom part fo...
- Jun 13, 2003
by
LarryK
We only charge for technical support/troubleshooting advice....
- Jun 13, 2003
by
I would say, if one guy buys used machine from a "dealer", t...
- Jun 13, 2003
by
iman
I don�t see how we could make any impact on the OEM�s to rev...
- Jun 16, 2003
by
Stefan Witte
I would like to say that if anyone is having problems gettin...
- Jun 19, 2003
by
To all involved in this thread,
The topic of registratio...
- Jun 23, 2003
by
Bruce Quigley