Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Calibration of Nozzle Holes on Mirae Mx350

Views: 405

#84152

Calibration of Nozzle Holes on Mirae Mx350 | 9 January, 2020

Hi Every one,

Thanks in advance for your help and support.

I am getting errors 'Nozzle pick up error' and 'Nozzle release error' on Mirae Mx350.

I have been told to calibrate Nozzle Holes using 'ANC' option in the Menu.

There is an option 'Sync ANC' in 'ANC' but I am not sure if this is the right one to use / how to use.

Can any one help please.

Best Regards,

Raees Rajput

reply »

#84173

Calibration of Nozzle Holes on Mirae Mx350 | 13 January, 2020

The holes are calibrated in MSetup. Generally, I have never had luck using the auto teach for the nozzle changer. We would teach them each manually. Before doing this, you need to narrow your issue down a bit more. Which head gives you this error? Is it all the heads, or only a specific head?IS it a specific nozzle? Is it a specific hole? Try picking the same nozzle with other heads, Also try swapping some nozzles around. An MX310 I use to run always had trouble with nozzle holes 1 and 10 (the holes farthest to the left), so much that I quit using those holes. Our nozzle pickup issues were usually related to the locking slide or air pressure.

reply »

Reflow Oven

pcb components vacuum pick up