Electronics Forum | Mon May 29 12:00:05 EDT 2006 | jbrower
Howdy Jack, That is a huge request, It would help if you start from the begining of your process and break down the problems that you are having.
Electronics Forum | Wed May 31 23:37:37 EDT 2006 | jacksaria
Hello EC, Thank you very much for the good input. I really appreciated. Our mounnters is Panasonic CM402,CM301. Do you have any suggestions/procedure how to reduce the sources of variance at each step of component placement process? regards,
Electronics Forum | Thu Jun 01 04:13:05 EDT 2006 | jacksaria
Hello TS, Our CM402 and 301 have encountered pick and throw. Do you have additional inputs?What is PT200?Please explain how it can help to optimize the program? regards,
Electronics Forum | Thu Jun 01 05:05:30 EDT 2006 | jacksaria
Hello EC, We already done your suggestion but still no effect. Feeders already calibrated. Do have additional inputs for this? Also is the barcode eliminate 100% wrong value component? regards,
Electronics Forum | Thu Jun 01 20:58:25 EDT 2006 | ec
Hi Jack, The throw out is it after vision or before vision. Do u have any msn account.....using msn is much easy to discuss the issue with you.
Electronics Forum | Thu Jun 01 21:13:48 EDT 2006 | jacksaria
Hello EC, Throw out is sometimes after and before. My msn account is j.saria@hotmail.com. regards,
Electronics Forum | Thu Jun 22 00:16:24 EDT 2006 | Gman
Hello, Has anyone had issues with voiding while using Imm Silver PCB finish. Does thickness of silver, contamination of the plating bath or other factors if you come point out cause voids due to the plating.
Electronics Forum | Mon Jun 26 08:08:32 EDT 2006 | davef
It does make you think the immersion coating is causing the voiding, doesn't it? We never have seen that.
Electronics Forum | Wed Jun 28 16:16:09 EDT 2006 | Gman
Good article. Would EDX analysis of the cross-section at the void joints be a good method to determine any plating contamination or solder mask issues?
Electronics Forum | Thu Jul 06 12:06:12 EDT 2006 | pavel
Rob, do you have any tip on reliable supplier of "really flat" flexible pcb? We tried several but all with issues. Thank you. Pavel