Electronics Forum | Sat Jul 23 01:51:04 EDT 2022 | poly
You'll find a lot of guides for cutting aluminium on the internet but basically, try and use a bigger end mill if you can, keep it at the right speed (not slower). We cut 1.6mm aluminium with a 3mm end mill. Smaller end mills didn't evacuate the chip
Electronics Forum | Tue Jan 12 10:28:23 EST 2016 | swag
Very cool - we're looking at 3D, too. I spend so much time designing then tweeking so it can be run on a 3 axis mill. 3D would make it easier! Good to know about laser, too. I always wondered the realities of it.
Electronics Forum | Tue May 11 10:13:48 EDT 1999 | Deon Nungaray
| Where can I get information for manufacturing flex "like" circuits continuously or in a roll to roll or reel to reel manner? | You might want to contact 3M electronics division. They might be able to help you.
Electronics Forum | Tue Mar 01 10:04:21 EST 2005 | Rob
We used durastone pallets, where you mill out the profile of the panel or board and it sits flat for printing. We secured them using 3M spray mount (for singled sided) and Kapton tape. Obviously helps to have bottom side heating in the oven as you
Electronics Forum | Mon Jul 03 03:42:32 EDT 2006 | teera
hello, pls check below item for paper stucks: 1)paper rolls diameter not over 60MM(new roll) 2)tension for roller clutch(silver u.s.c only) 3)make sure the under screen cleaner ROUGH ROLLER is clean and free for solder paste.so that it can turn smoot
Electronics Forum | Tue Feb 26 19:24:22 EST 2008 | swag
We're in the market for a new depaneling router for high volume flex circuit builds. I have no experience with them. At this time, we do all our low volume stuff on a 3-axis mill. Any advice on what to consider and some recommendations of the best
Electronics Forum | Thu Jul 27 12:30:37 EDT 2006 | Rob
Hi David, we used the following techniques in high volume production, depending on the type of flexi-board: (all were in milled pockets in a durastone pallet) 1) Kapton tape top & bottom 2) Spray mount & samll amount of kapton tape (you only had
Electronics Forum | Thu Jul 06 08:16:53 EDT 2017 | claudea2
Hello, I have 3 Quad 4C one with Quad Align and 2 with the older lasers. All 3 machines have a placement offset issue. Every 4 or 5 boards one of the machines has a placement offset of about 10-20mills in one direction. A reset usually brings it back
Electronics Forum | Wed Feb 02 14:55:34 EST 2005 | JB
We have used small hi temp labes, that are placed on our panels, boards before reflow. Each operator has a roll of labels with an assigned number. 4 operators, label 1, 2, 3 and 4. It worked well for us.
Electronics Forum | Tue Jul 17 04:16:02 EDT 2007 | jasondmx2
It's a small diode with orange core - has a blue kathode stripe it reads "3" then as you roll it over it reads "2c" That is it. I really would appreciate any help in identifying this diode and understanding the coding method used on these diodes. Th
.gif)
winsouce.jpg)
.gif)