Electronics Forum: ati 24 inch conveyor (Page 1 of 1)

We are now building 48 inch (1200mm) SMT assemblies.

Electronics Forum | Tue Feb 23 09:26:34 EST 2016 | tombstonesmt

Good to hear! Never dealt with an assembly that large. 24" is the longest we've built. One issue we encountered was bowing due to the vacuum seal being too tight. Bowing caused transfer issues between conveyors and equipment. -TSS

SMT MACHINES

Electronics Forum | Fri Sep 30 09:03:55 EDT 2005 | davef

Pick and place: * Fuji: The largest pcb size is 20" by 18" for pick and place; 18"x14" for chip shooters. * MYDATA has machines that can be configured to 34" X 44" X 0.500" * Fuji has the NP XL series that will allow 27 by 23 inch boards using a con

U.S. PCB Suppliers 48

Electronics Forum | Thu Mar 08 07:24:40 EST 2018 | proceng1

That's what I said when we started talking about 48inch boards. Everything changes. New printer, bigger stencils, new pick & place. Different even profiling (the board is in 3 zones at the same time). Plus board racks don't work well. The old Boa

Placement Equipment and Long Boards

Electronics Forum | Mon Apr 09 10:16:14 EDT 2007 | davef

Pick and place: * Fuji: The largest pcb size is 20" by 18" for pick and place; 18"x14" for chip shooters. Fuji NP XL series allows 27 by 23 inch boards using a conveyor. * MYDATA has machines that can be configured to 34" X 44" X 0.500" * HSP 4796A a

BTU Paragon 150 Reflow Oven

Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc

You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa

Brush-Up Your Intermetalics!!!

Electronics Forum | Thu Jun 17 21:31:06 EDT 1999 | Dave F

| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w

Re: Brush-Up Your Intermetalics!!!

Electronics Forum | Thu Jun 17 22:10:48 EDT 1999 | Earl Moon

| | | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | | | for example: | | | | | | Solder Bridge | | | 1.verify amount of flux been aplied. | | | 2.verify turbulance on

  1  

ati 24 inch conveyor searches for Companies, Equipment, Machines, Suppliers & Information