Electronics Forum | Fri May 20 09:45:57 EDT 2005 | young
Hello, I was wondering if anyone knows where I could get a solder pot exhaust fan? Here are the specifications: Manufacturer: Emerson Description: Belted Fan + Blower Duty Model: S63CXJDJ-7165 CAT: 5795C HP: 3/4 RPM: 1725/1140 Voltage: 115 Hz: 60
Electronics Forum | Wed Aug 14 13:39:59 EDT 2013 | eadthem
Most of this you have probably covered, but these are what have caused heating issues for us in our 1707 EXL. First, you would probably notice, but check that all blowers are turning by looking at there cooling fans in the top and bottom, Our 170
Electronics Forum | Thu Jan 18 07:30:13 EST 2007 | realchunks
It could be the blowers in cooling section of the oven. Try turning them off. It could be the belt is not level.
Electronics Forum | Mon Jun 22 16:34:14 EDT 2020 | stephendo
What I have seen used are belt driven roof mounted exhausts. There would be a drum fan that is driven by belt and motor. That way the fumes never go over the motor or the belt. We would have to replace the belt every couple of years or so but then it
Electronics Forum | Wed May 30 19:08:58 EDT 2007 | darby
Mark, You should find that the blower motors and heaters will be replaced free of charge by Heller. I have four Heller ovens and have found that to be the case. I am the original purchaser however and it may be different if you have purchased the mac
Electronics Forum | Tue Nov 21 13:25:25 EST 2006 | jax
Depending on Zone Temperatures, Belt Speed, and Board Density... Some Convection Ovens will drop Zone Temperatures faster than others. They recover by increasing Air Circulation. This can make parts fall off the Bottom-Side that otherwise would
Electronics Forum | Sat Mar 27 12:44:06 EST 2004 | Bill
Just wondering, what kind of dryer blowers does your wash have? Ours our Sonic 100c --and we have had problems with belt and bearing failures. Mostly due to water cooling problems, belt tension and worn/damaged pulleys. We are getting a handle on
Electronics Forum | Tue Nov 13 00:05:11 EST 2012 | eadthem
Typical problems with our heller 1707 EXL would be blower issues. We have almost replaced every blower on the top sense purchase. Fortunately Heller is very good about honoring there warranty on the blowers which is quite long, Might be lifetime not
Electronics Forum | Wed Apr 21 21:47:46 EDT 1999 | Steve Gregory
| HELP | I need any information on how to purchase "Metal baskets" | (dimensions 3" height x 18" width and length) for our HUGE cleaning machine for our PCBA's. Pleas eif anybody could give me sales info, or company information it would be greatly a
Electronics Forum | Wed Aug 21 12:57:41 EDT 2002 | dragonslayr
I would like to address several issues. First, your reflow is 150 PPM for the same exact assemblies that have lower PPM's? or are you giving a 150 PPM rating for all products produced through the reflow process in a specific time period? Reflow is a
