Electronics Forum | Thu Oct 21 11:15:00 EDT 2010 | jorge_quijano
Do you know in which axis the problem occurs? usually when "hardware limit error" shows is because one of the axis touches the sensor of the limit, this is to prevent the mechanism hit something, If you machine is used, you can check if there is a mi
Electronics Forum | Tue Oct 11 19:17:29 EDT 2005 | Dave
Hi Stephen! The nozzle change happens at a much slower speed to what it runs at during pick and place. They are a great machine...when everything works on them ;-) I tried sending through the proper data again and rebooted the machine. A interest
Electronics Forum | Tue Mar 12 17:02:32 EDT 2019 | eurolan
Hello, our Samsung CP45FV NEO is suddenly throwing an [1002] ALARM occurred in WIDTH axis. I guess it has to do with the automatic conveyor width function. Anyone can help to solve this? Thanks!
Electronics Forum | Tue Aug 10 20:34:44 EDT 2021 | jamesatqkits
Hi Could you explain what the IF board is? I am getting a 1002 ALARM occurred in MIR axis, i cannot figure out what its trying to tell me. I have never been able to make this machine work. Would you have any ideas? Thank you have a great day. I was r
Electronics Forum | Mon Nov 26 02:09:55 EST 2018 | bukas
yes I am, today im going to try to load backup image on to HDD. this error occurs before any machine movement, so it might be SW error... at least I hope so
Electronics Forum | Fri Aug 28 17:47:59 EDT 2020 | inspiredmorris20
thanks Stephen!! I'm testing for voltage and have found 24v going through the E-stop to the main switch. If i trip the E-stop i can disengage the main switch. I have no more control to the hardware then that. The software is not throwing any code ot
Electronics Forum | Mon Aug 31 11:52:28 EDT 2020 | inspiredmorris20
Hello Jon, I appreciate your reply, correct there are 2 red (24v) that control the main power and 2 blue (they control the power to the units operation keys ready, start, stop, reset, change feeders.) additionally there is a red jumper wire on the E
Electronics Forum | Mon May 24 05:56:59 EDT 2021 | bukas
hello James, you should be getting error message " no pneumatic pressure " when trying to get machine into READY state with no air supply. maybe you should check HDD health. while you are there, make HDD backup; and if machine uses ATA driv
Electronics Forum | Sat Jun 12 05:54:53 EDT 2021 | starsanat
Hello dear users I got this message on machine: "ALARM occurred in WIDTH axis". How can I fix the problem if anybody has this before
Electronics Forum | Wed Jan 05 16:43:41 EST 2005 | mee13
what size feeder are you using there, when does this alarm occur :during prod?
.gif)