Electronics Forum | Sun Apr 11 11:39:52 EDT 2010 | manchella
When we have sent some of motherboards for reliability testing in a tird party laoratory. It is found that when Dye&Pry is done after 600 cycles of Thermal Cycling, in LGA socket only one of the corner solder joing had 100% type 3 crack. All other so
Electronics Forum | Tue Jun 07 16:19:58 EDT 2005 | davef
Q1) How to identify on good or bad ICs lead that could contribute to dewetting? A1) Distinguish between good or bad IC that could contribute to dewetting by testing for solderability, according to J-STD-002. Q2) What actions that must be taken in fa
Electronics Forum | Tue Aug 16 09:37:58 EDT 2011 | blnorman
Dye and pry is frequently used on BGAs to determine if there is a crack at the board level or component level interconnect. C-SAM will show internal delaminations of components, not sure how well it would work with solder joint cracks. You can also
Electronics Forum | Sat Jun 05 13:38:22 EDT 2021 | ppcbs
For Linear Tech LGA's we solder bump the LGA using a .30mm solder ball then reflow with a tacky flux. This will provide a void free solder joint and adds a little height to the solder joint in case you use a flux that you want to clean from under th
Electronics Forum | Mon Aug 28 18:57:41 EDT 2000 | Earl Moon
Steve, This is a good, well repeated, not identified by IPC yet issue. I, and some others in industry, for years have proven and recommended smaller pads for various devices. I, and some others in industry, use 0402 pads for 0603 device types. IPC o
Electronics Forum | Thu Aug 16 13:57:30 EDT 2001 | Hussman
Ouch! I thought that went away 12 years ago! Visual inspection to IPC standards should be used. Pulling and pushing leads is not even close to being consistent. I bet your customers or ISO auditors have never seen this practice. If they must pul
Electronics Forum | Fri Jun 04 11:54:22 EDT 2021 | cbart
We do this quote often with our older Summit machine. there are a few ways to do this. all of these are assuming you have parts on the boards already and are working around them. 1- if you have a good tech that can add solder to the pads on the PCB a
Electronics Forum | Wed Dec 29 14:30:28 EST 1999 | Dan Woodward
I am not sure if I have seen an article comparing solder joint strength Vs pressfit although I am sure this has been researched by literally hundreds of companies before they felt comfortable going to pressfit. I know one of the issues with solder is
Electronics Forum | Fri Aug 08 07:15:49 EDT 2008 | davef
Hot tear occurs at the surface of the solder connection. The surface will look like someone tore the surface apart. So, it is a crack or fracture formed prior to metal solidification.
Electronics Forum | Sat Oct 02 03:27:52 EDT 1999 | Brian
| I am currently in the middle of a company wide war and I'm looking for data (AMMO). Here are the problems: | | 1) I am looking for anyone who has done or seen any reports on Thermal Shock to smt parts and/or via holes caused by Soldering Irons at
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
