Electronics Forum | Tue Feb 05 19:00:18 EST 2013 | marcelorotofrance
I found problem, it was a faulty connector on the align processor card. So, Mr. Bobpan, I thank you very much for your invaluable guidance. P.S. My employer has been very clever and have purchased a 18 years old/ 25000 run hours/ third-hand equipmen
Electronics Forum | Mon Aug 17 17:01:31 EDT 2020 | rgduval
+1 to what Sr. Tech said. I'd also add that you could have some uneven deterioration of the centering jaws. Check by doing a couple of things (this will help check if the tool/tip is bent/deteriorated as well): 1. Turn off mechanical centering, and
Electronics Forum | Thu Jul 31 10:37:25 EDT 2008 | 18424
I agree with RLM. What i have seen is that quad had a problem with the gounding system of the quad align unit. An additional ground wire was added at the quad align cage,and to the PCB located inside the front right access panel. I don't have a machi
Electronics Forum | Wed Mar 25 18:29:47 EDT 2009 | badnewz
My Quad IVc's will also do the same thing. Mine are equipped with CyberOptics scanners, not QuadAlign. The Cyberoptics scanners do go bad and once they do, they get very warm to the touch and at the same time, if the Quad is reset, the theta axis wil
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Mon Feb 04 06:48:50 EST 2013 | bobpan
Do a function 30 on the hht and you should get a nozzle height of around 200. If its not and its around 1 you have something on the quad align lens and you will have the exact problem you are having. Hope this helps... Good luck
Electronics Forum | Sun Feb 10 15:14:25 EST 2013 | marcelorotofrance
After an in depth examination, I found that the problem was not a defective connector as I thought in the first place. Actually is a broken through-hole on the Quad Align sensor. I requested a spare part to PPM. Mr. Bobpan, thank you again.
Electronics Forum | Wed Jul 26 22:47:14 EDT 2006 | seth
I have problem with RV/D axis counting error. I have tried several things, but it just doesn't help. These are the things I had tried 1. Check all 12 segment for dirty. 2. Check DP motor for proper operation. 3. Replaced reader. In order for me to pe
Electronics Forum | Thu Jul 27 09:48:16 EDT 2006 | john_smith
Seth, have you tried the zero point on the star?
Electronics Forum | Sun Jul 30 11:50:22 EDT 2006 | john_smith
Do the sleeves spin freely in the segment? Could also be that the reader needs to be readjusted.
.gif)
winsouce.jpg)