Electronics Forum | Thu Nov 03 01:39:53 EDT 2022 | spacecase
Thank you for the response, left the machine turned off for a good period of time and somehow the issue solved itself. I was able to calibrate the next day and homing hasn't been an issue. However now I'm having another problem where it gets 4 comple
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Wed Aug 24 09:20:25 EDT 2016 | dekhead
Suspect comms link error from Y3 to Y1 crate. COM 2 off of CPU, depending on board. If CPU board has RS485 port it is direct to back panel of PC; if older board it only has RS232 and thus requires 232/485 converter board (internal to PC). then direct
Electronics Forum | Wed Aug 31 08:12:37 EDT 2016 | ttheis
Search for the bios or motherboard on ebay. Type in the part numbers you find on the boards and see if anything comes up. Often these are standard pc boards. I've repaired my old MPM by finding the cards on ebay cheap.
Electronics Forum | Thu Sep 01 08:30:54 EDT 2016 | bukas
Certainly possible CPU board issue; but check PC > power supply, that all DCV are present and > strong. > > www.dekhead.com > Certainly possible CPU board issue; but check PC > power supply, that all DCV are present and > strong. > > http:/
Electronics Forum | Wed Aug 31 09:35:15 EDT 2016 | dekhead
Certainly possible CPU board issue; but check PC power supply, that all DCV are present and strong. www.dekhead.com
Electronics Forum | Fri Sep 02 04:18:48 EDT 2016 | bukas
i have tested voltages on Processor board X12. all voltages are ok and stabil but +VPP (PT8 - TP9), it reads 0 volts
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
.gif)
winsouce.jpg)