Electronics Forum | Wed Apr 02 13:59:05 EDT 2008 | markhoch
Ahhhhh yes. I remember those well. We referred to them as "Geez" clips though. (Because when you went to snap them on, if they slipped at all, they'd go flying and you'd most often end up saying "Geez!!!") We bought metric Geez-Clips, (I believe they
Electronics Forum | Wed Jan 06 14:34:20 EST 2010 | ppwlee
Hi, Has anyone have experience with manual soldering iron using automated wire feed? I am looking at poke yoke manual soldering 5 pins LCD and wondering if there are ways to control the volume of the solder applied to the board to minimize missing s
Electronics Forum | Thu Jan 14 15:36:23 EST 2010 | tds
JBC Tools has a wire solder feed solder iron. You can control how much is dispensed to the tip. I have sold several of these to customers soldering wires in to terminals. The hand piece is bigger than the typical solder iron but it beats the alter
Electronics Forum | Wed Apr 02 17:52:41 EDT 2008 | fsw
Sr. Tech, We have a IP III on one of our lines. We were hand placing an Samtec SMT connector MMT-108-01-T-DH series. I asked our SMT tech to get the IP to place it & he said we need tabs on the connector. So we got the "tab" version. Now he is not a
Electronics Forum | Tue May 21 15:30:21 EDT 2013 | williamaxler
There is two different ways to make this work. To get the Add Project button enabled find your EasyOLP installation folder and modify OLPoptions.ini change MultiProject to 1. Now you will be able to add multiple jobs together and optimize. You c
Electronics Forum | Fri Aug 31 04:55:50 EDT 2018 | sophyluo1985
Hi Karl, We also supply YAMAHA and JUKI parts. Our website is : Http://www.goldlandsmt.com Once you need, we can quote to you for your reference. ok? Have a nice day! Sophy GoldLand Electronic Technology Co., Ltd 88#, Nan Ling Road, Xin Qiao, Sha J
Electronics Forum | Tue May 05 07:38:52 EDT 2009 | markgray
I found that if the feeder correction is turned on the offset of the verifier is transfers to the feeder data for some reason. I turned the feeder correction off and the problem went away.
Electronics Forum | Mon May 04 21:31:55 EDT 2009 | dougt
I haven't worked on that machine in a while but here's a couple things to check. I'm pretty sure the verifier "feeders" have to be in the first feederslot on each side, make sure they are there. I think offsets for the verifier "feeder" are automat
Electronics Forum | Mon Jun 26 09:33:07 EDT 2017 | bobpan
So I am assuming that you are using the IQ feeders option on the machine. First thing I would check is to make sure you don't have an older feeder on the machine. There was a certain point where quad feeders would be 'IQ' capable or not. You may have
Electronics Forum | Wed Apr 01 08:25:56 EST 1998 | Mark Anderson
| Does anyone know where on the net I can find a list of | FUJI feeders? | I'm looking for a feeder that can take 88mm tape? | Any information would be apreciated. | Thanks | Kim Krauch Your best bet is Hoover Davis who make IP compatible feeders a
Major in whole line of SMT equipment, especially in Mounting And printing and AOI SPI, Serve Parts and acceccories.
Training Provider / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Floor 1,D Building,B area,Dongsheng Techwin Park,Bao'an District
Shenzhen, 30 China
Phone: 008618566662725
