Electronics Forum | Fri Jun 30 17:38:17 EDT 2006 | grantp
Hi, Thanks guys and that's a big help, as I thought we had to have the lot flushed out, and I guess I must have transferred my worries about us flushing out all parts to our sales channel as well! Regards, Grant
Electronics Forum | Wed Oct 17 21:33:16 EDT 2007 | davef
What service company do you use for the sharpening of dykes, side cutters, diagonal cutters? What process controls do you suggest in maintaining good process from such a service company? While we're on the topic, we have aways used semi-flush cutte
Electronics Forum | Mon May 20 14:06:10 EDT 2002 | russ
I have always installed them flush to board unless noted on assy. dwg. Russ
Electronics Forum | Sat Sep 25 09:00:59 EDT 2010 | slwolbert
I managed to bypass this issue by flushing FIP2 and sending status and proper back.
Electronics Forum | Mon Mar 13 15:02:43 EST 2000 | Boca
Breakaways are clearly the best solution for us in manufacturing. A big difference between wavesolder pallets and SM pallets is the need for a flush top surface for stencil to PCB contact in the printer. One vendor has a device which hold the PCB
Electronics Forum | Mon Mar 13 15:02:43 EST 2000 | Boca
Breakaways are clearly the best solution for us in manufacturing. A big difference between wavesolder pallets and SM pallets is the need for a flush top surface for stencil to PCB contact in the printer. One vendor has a device which hold the PCB
Electronics Forum | Mon Dec 18 19:31:33 EST 2023 | kojotssss
Surely somewhere the cleaning or rinsing liquid gets to the other chamber. It is possible that the chemical migrates to the flush or flushes the chemical into the chamber. I have had a similar situation, high foam, injection vertical spray offline st
Electronics Forum | Thu Aug 17 09:24:28 EDT 2006 | markb
We are looking to possibly counterbore a coule of thru holes in one of our PCBs. We would counterbore the top side, and the only trace is coming out of the bottom side. The reason is to mount some LEDs flush with the board. They have some flash wh
Electronics Forum | Tue Jul 29 17:59:53 EDT 2014 | guts1872
I have had to flush the ram when replacing a TEP controller. These are kind of scetchy instructions from my notes, never could get PPM to send me any procedures. Hope this helps. Plug keyboard and monitor into RT computer and navigate to 2kla/RT/TEP
Electronics Forum | Fri Jun 09 07:56:25 EDT 2017 | prdmm1
our company has just purchased the MC110 High-Accuracy Manual Stencil Printer. the only thing I'm not sure about is how to use the PCB Edge Stopper. how is this used? the groove with the stoppers on it is too deep to hold a board because it would s