Electronics Forum | Thu Mar 01 23:05:29 EST 2007 | Khader
Kindly explain to me how to calculate 24V DC Relay Coil Impedence for a 2PDT Relay.
Electronics Forum | Thu May 20 09:20:08 EDT 2004 | jsk
Voltage checks out ok after i unplug the monitor and unplug the dc voltage suppy to the y1 enclosure. I lose the 24v and 5v line completely when i plug these in and voltage drops on the +12v and -12v, which leads me to believe a bad power suppy. What
Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
Electronics Forum | Wed Apr 28 15:23:47 EDT 2021 | procyon
Hello Deni, Thanks for the comment. Could you provide a bit more information as to what pins are used to accomplish this specifically for Universal Instruments Blue label older feeders? Here is the pinout I got from UI but it does not show a statu
Electronics Forum | Fri Jan 18 07:01:41 EST 2008 | cyber_wolf
Hi, The solenoid that sits on top of the vacuum generator on my Fuji bare board loader is croaking slowly. Fuji will only sell me the entire generator assy. which cost more than I paid for the loader. The only markings on the solenoid are DC24V 540
Electronics Forum | Tue Jun 30 15:03:18 EDT 2009 | Geo
Dave, We have both situations where the grounded electrical equipment on the mat has insulative pads or does not have insulative pads. The workstations we have this problem with are test stations where electrical equipment is used on the test bench
Electronics Forum | Sun Nov 27 16:53:39 EST 2016 | ttheis
Our UP500 has been running great for a few months then the AC/DC 5/12/24V power supply stopped working and the PC could not communicate with the cage. The PC screen also got very noisy. We replaced the power supply with a used replacement and the ma
Electronics Forum | Fri May 14 15:28:39 EDT 2010 | timryder
I have an application I'm trying to solve which would allow me to vary voltage going to an Electric Solenoid at 24v ~3.0amps DC. What I want to do is create a device to vary the voltage going to the Solenoid using a pulsed digital input. I have a mot
| 1 |
.gif)
