Electronics Forum | Mon Oct 13 15:33:36 EDT 2014 | rgduval
So...today, we were able to get rid of the z axis not mounted error. It looks like we did so by modifying the settings in axes location (matched them to the beam 1 settings). Now, when we try to lower the nozzles, we can hear a relay or switch clic
Electronics Forum | Tue Oct 14 14:08:22 EDT 2014 | dilogic
No, each card in LP servo rack drives only one motor. But there is an servo cotnroller board (actually 3 of them) in the VME rack (where all computers are). Third one from the left(slot13) controls head2 theta and z axis. That might be a cause of you
Electronics Forum | Mon Jul 18 21:36:18 EDT 2022 | ttheis
We have two GSM machines (4-spindle, single beam) and had a camera fail on one machine. We decided to clean and calibrate the cameras on both machines. One machine we had no problems and all is working properly. The other machine will not pick up the
| 1 |
