Electronics Forum | Thu Aug 17 06:02:37 EDT 2017 | smeissner
Is anyone using an AOI machine for through-hole > checking? We have a need to check post-build on > some PCBs', but there doesn't seem to be any > obvious AOI solution. > > Is there such a beast > available? Check Goepel. They developed a Spec
Electronics Forum | Tue Jul 18 15:16:40 EDT 2017 | robertbronx
Showing on screen this message: MIPR2: Fatal Error. Reloading Motor Controller M First time I connect and only have this message on screen. The manual only says; 1) SOFTWARE PROBLEM IN THE MOT-M SERVO PROGRAM. 2) THE MOT-M OR MI board is broken. Plea
Electronics Forum | Wed Jul 19 02:37:24 EDT 2017 | bukas
Hello everyone, i recently got Ersa ETS 330 wave machine '94. I got it running and heaters and flux pumps are ok, but I have problem with 2nd wave pump. It runs for 10-15 sec and then shuts down with error message on display. I checked bearings and
Electronics Forum | Sat Jul 22 14:50:04 EDT 2017 | spitkis2
It depends on the thermal mass of your assemblies (boards and components). Generally, if boards are small with few layers, the additional mass of components may have a significant impact on reducing the peak temperature. If boards are larger with s
Electronics Forum | Thu Aug 10 04:20:37 EDT 2017 | Alexei
Hi, We have solutions for your problem that used by many our customers. You can read about our tooling products (see QPlace, QPlace UPD and QPlan) on our website: http://www.proventustech.com. Also you can contact me through email: alexeis@proventu
Electronics Forum | Wed Jul 26 11:13:06 EDT 2017 | jdengler
It can be done and is done all the time. You need to check with your customer about this since you will not have clean square corners along the edge. If they are snapping the boards into a holder they may need the square corners to securely hold th
Electronics Forum | Wed Jul 26 11:35:34 EDT 2017 | proceng1
You are referring to the web left after the break, right? I figured it was possible, but I did some searching and couldn't find anything about it. Do you have a board or picture you could post of this?
Electronics Forum | Fri Jul 28 12:13:38 EDT 2017 | dontfeedphils
Ironically enough, inline wash system belts work well for placing on top of small assemblies inside wash basket to avoid bouncing around like you've seen. This of course assumes you have access to an old belt like that. Point being, try to find som
Electronics Forum | Tue Aug 01 09:27:13 EDT 2017 | tmennink
Hi all, We are having a lot of trouble with mis-pick trying to place silicone dome LEDs(3535 package) It seems that the silicone of the LEDs is sticking to the side wall of the carrier tape pocket. The vacuum nozzle would normally suck up the led an
Electronics Forum | Tue Aug 01 11:09:44 EDT 2017 | mmjm_1099
Can you supply the following information to help with your question. 1. MFG P/N 2. Pick and Place machine being used 3. Type of nozzle and feeder being used on machine. We place a wide variety of LEDs and had similar issues and have to use custom