Electronics Forum | Tue Jun 14 10:48:03 EDT 2005 | Paul
We evaluated several machines a couple of years ago and ended up selecting an Agilent SJ50. Fast machine but very limited on joint inspection. Also does not detect missing components reliably which you would normally take as a given on an AOI system.
Electronics Forum | Tue May 31 10:09:17 EDT 2005 | gregp
I am a supplier of flexible pick and place equipment, not a end user. Your question is about new pick and place machines with high feeder capacity and SMT lines with redundancy. That is exactly what the C5 Placement machine from Contact Systems is.
Electronics Forum | Tue May 31 11:43:27 EDT 2005 | ??
Worn out is all relative. If the machine is in a factory on a dirt floor with no air-conditioning.....it could be "worn out" after 1000 hrs. but then again....if it is in a well kept building with the proper maintenence........10000 hrs could be fine
Electronics Forum | Tue Jun 07 11:26:12 EDT 2005 | gregp
How is pointing out an obvious drawback (for a flex machine) considered "going after with conjecture"? Fuji obviously is a world leader in the P & P arena. The NXT is not the right machine in this case. If you like the NXT, it is no big secret that
Electronics Forum | Mon Jul 03 22:48:42 EDT 2006 | eyryren
Dear ve7khz We are the manufacturer of SMT accessorial material.stencil clean roll and splice tape.We are can manufacture many style stencil clean roll for kinds of screen printer machine and splice tape special for kinds of placement machine. If yo
Electronics Forum | Thu Sep 28 17:40:41 EDT 2006 | fujismt@btconnect.com
Fuji AIM users. If you wish to splice 8mm component tape reels using this machine, visit http://www.fujismt.com and look at Fuji Chemical FC8A Joint Tapes. Ideally suited and in use on the Fuji AIM machine, FC8A is easy to use and available for next
Electronics Forum | Tue May 31 12:04:04 EDT 2005 | chunks
They both have good and bad points, depending on part size and such. The speed of the turret is great but the large part size capability and co-planarity check some of the X-Y machines is a life saver. I'm surprised no one has come up with a combon
Electronics Forum | Tue May 31 22:16:24 EDT 2005 | hottipmfg
Hi, I'm new to this field. I'm looking for a third party software that can program the Zevatech FM720 Pick&Place machine. I know ScanCad provides service for this machine. Any knowledge to a reasonable cost software is appreciate very much. //Andrew
Electronics Forum | Wed Jun 08 13:06:36 EDT 2005 | jimby
You will have to machine the part off down to the top of the balls. Wick solder off from individual sites one at a time. All that will be left is Parylene shell where balls once were. Take an orangestick and alcohol to break up and remove. Tricky par
Electronics Forum | Thu Jun 09 12:21:07 EDT 2005 | ratsalad
James, I have worked at a couple of different companies and both have reduced their changeover times significantly. What type of placement machines do you have? Do you use customer part numbers or do you have your own internal part number for co
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
