Electronics Forum | Fri Dec 17 09:49:34 EST 2010 | remullis
Hello to all, I am having problems with the X,Y table initializing. I noticed the Skew motors 17M1 and 17m2 are moving but the table keeps wanting to drive in the left direction standing in front of machine. It will keep trying to drive until it tim
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Wed Nov 30 20:43:06 EST 2016 | ttheis
OK, so went to power up again today and had the same kind of issues. The 24V and 5V lights on the cage flicker dimly about every 500ms. I tried my trick of disconnecting the +24v lead to the lift table amp and it acted the same, so it didn't work th
Electronics Forum | Tue Mar 14 18:47:29 EDT 2017 | simons
One of our Speedline Sigmaprint 400 paste printers has developed an issue. The XY table will no longer move up or down and we cannot initialize the machine for any type of on board diagnostics. Anyone familiar with this type of failure?
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Sun Nov 27 16:53:39 EST 2016 | ttheis
Our UP500 has been running great for a few months then the AC/DC 5/12/24V power supply stopped working and the PC could not communicate with the cage. The PC screen also got very noisy. We replaced the power supply with a used replacement and the ma
Electronics Forum | Fri Mar 17 11:26:10 EDT 2023 | proceng1
We got rid of our UP1500 2 years ago. I don't see the manual on the server anymore. I'm wondering if someone purged it. I do have all the ACCUFLEX stuff, which for our machine was pretty much the same. The software was identical, but with a few op
Electronics Forum | Tue Aug 29 10:36:09 EDT 2006 | Chunks
With the UP2000 that has vacuum board hold down, the Grid Loc hoses defeat the vacuum in order for them to exit the work table. Big boards require more girds, thus more hoses. Set-up between large and small boards takes time to remove or add the gr
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Wed Sep 01 05:44:18 EDT 1999 | Wolfgang Busko
| | I'm in univerity research on SMT assembly systems. Especialy Simulation and Optimisation using OR-Methods. We developed flexible simulation models of various assembly-machines and use them for performance estimation (Components per hour) under di