Electronics Forum | Wed Nov 02 01:53:41 EST 2005 | pavel_murtishev
Hello, Thank you for answer. We are using second hand machine. What do you mean saying that �stencil is not height on all 4 corners�? Does it have some inclination between corners? I mean that three corners of stencil are matching with PCB fine and
Electronics Forum | Sat Nov 05 20:23:11 EDT 2016 | sarason
Close but not to close, would have to be the spec. Or depends on your separating technology. Prerouted boards on a panel, you could go right up to the edge. V-grove you will need more distance, maybe 2mm's or more. The distance from the panel edge to
Electronics Forum | Mon Jan 22 09:06:21 EST 2001 | jmlasserre
Product concerned: Sdram memory. Due to the net resistor size and shape (0603, the lead of this component is very close to some vial hole. What is the minimum clearance we must have between a component lead and a pad or via ? For the pcb design th
Electronics Forum | Fri Oct 28 08:37:06 EDT 2005 | pavel_murtishev
Once again, it isn�t the process problem. It�s machine problem. I�ve tried to change all of the parameters: printing speed, printing pressure, snap-off speed, snap-off distance, etc. No any effect. Defect still exists with different process parameter
Electronics Forum | Fri Oct 28 06:55:53 EDT 2005 | pavel_murtishev
Hello! I suspect that our MPM AP25 has separation problems (poor stencil � PCB separation). I observe a lot of �dog ears� after print stroke. And this is 100% machine problem, I�m sure. What machine parts should I check first time to avoid separatio
Electronics Forum | Sun Oct 09 11:16:06 EDT 2016 | mekmat
Hello, I would like to ask you about the minimal distance between components and border of pcb especially V-cut to avoid crack of component during depaneling? I need some standard (IPC or something) where is this defined? Thank you for your support
Electronics Forum | Sun Oct 30 12:39:13 EDT 2016 | mekmat544
Thank you for your answer, but I am litte bit confusing. There are parameters of V-scoring but with put values. How can I get values for V-scoring for pcb 1,6mm thickenss. Thank you. M.
Electronics Forum | Sun Oct 09 16:57:30 EDT 2016 | davef
IPC 2222A Sectional Design Standard for Rigid Organic Printed Boards, 5.3 Design Requirements for Printed Board Assembly
Electronics Forum | Tue Nov 01 12:28:36 EDT 2016 | comatose
It depends. Are you hand breaking them, rotary knife or linear knife? Hand break you want to be about 5mm (and it isn't a great practice even then) with a rotart knife you want to keep parts probably 3mm, especially capacitors. With a linear knife we
Electronics Forum | Mon Mar 13 15:10:52 EST 2000 | Stuart Adams
Assuming agressive design rules what is the minimum distance I can get away with between the board edge and a SMT pad and between the board edge and a plated mounting hole ??? (The board is only 1"x2" and the mounting holes are 80 mil dia, 125 mil
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
