Electronics Forum | Wed Aug 17 14:30:58 EDT 2005 | russ
I usually see this with mask that is not fully cured from the PCB shop. This probably agrees with the baking statement that you made.
Electronics Forum | Fri Apr 16 11:51:26 EDT 2010 | shawnvike
Looks like a simple variance in the solder mask discoloring. Shawn
Electronics Forum | Thu May 14 22:45:46 EDT 2009 | davef
You're correct. It's a peculiar looking defect. With measling, we expect to see discrete white spots or crosses just below the surface of the base material. We don't see that here. We do see a similar condition at almost every PTH in the picture, a
Electronics Forum | Thu Jul 15 15:55:41 EDT 1999 | nards penalosa
| | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec d
Electronics Forum | Thu Jul 15 12:26:56 EDT 1999 | Earl Moon
| We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec dwe
Electronics Forum | Thu Jul 15 19:05:58 EDT 1999 | Earl Moon
| | | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec
Electronics Forum | Thu Jul 15 11:57:15 EDT 1999 | nards penalosa
We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec dwell
Electronics Forum | Wed Jul 28 17:34:27 EDT 2004 | Steve Stach
Hi Ralf, This discoloration may be re-oxidation. Fluxes are supposed to do three things (1) remove oxide, (2) promote wetting, and (3) protect surface from reoxidation. The solder paste possibly is not protecting from reoxidation. Best Regards, St
Electronics Forum | Fri Jan 19 10:43:28 EST 2007 | jimmyjames
You guys are all joking right?! There aren't any contaminates in your solder, the different colors on the surface are completely normal and even expected. The top layer of solder oxidizes and the structure of the surface resembles crystals, refract
Electronics Forum | Wed Feb 14 16:58:12 EST 2018 | cbart
you would be best to get this from your paste/solder manufacture. but here are some rules of thumb: -Solder paste out of fridge before use - get out the night before needed.. don't let your op's warm on the oven!! you will regret that! if not over ni