Electronics Forum | Sun Apr 25 10:28:46 EDT 1999 | Joe Cameron
Hello all, Been doing some comparisons on joints made using the soldering iron versus reflowed solder paste (on a QFP package). The difference is quite significant: the joints made by the soldering iron are inconsistent and in many cases not filled
Electronics Forum | Thu Apr 01 12:31:39 EST 2004 | russ
one more thought on this, When these boards are built new do we not have solder paste on the ground pad and then reflow? Has this caused any misregistration for you? I am assuming that you are not pasting the leads with the ground pad correct? I
Electronics Forum | Thu Apr 01 11:27:17 EST 2004 | Jimmy
I have some fine pitch QFP's to rework with our smt rework system (forced air). There are no intitial concerns in removing the component (we havent actually begun the rework process) however, installing a new chip presents a problem. The QFP has
Electronics Forum | Fri Nov 09 16:57:27 EST 2001 | davef
Sure, it�s fine to use the proper amount of flux and no solder when reworking BGA. Recognize that these new solder connections have less metal and a lower standoff than similar BGA solder connections that have not been reworked. This undoubtedly
Electronics Forum | Thu Apr 01 13:16:56 EST 2004 | Jimmy
>When these boards are built new do we not have solder >>paste on the ground pad and then reflow? Has this caused >>any misregistration for you? We didnt assemble these boards so I have no knowledge of the manufacturing process that was implemented h
Electronics Forum | Fri Jul 09 11:19:58 EDT 1999 | Carol Brumfield
Has anybody successfully used an automated dispensing system to put solder paste dots on .5 mm pitch pads?? I need to replace some Meritec tsop sockets and I don't want to use the single site stencils for .5 mm parts.
Electronics Forum | Sun Apr 25 11:18:45 EDT 1999 | Earl Moon
| Hello all, | | Been doing some comparisons on joints made using the soldering iron versus reflowed solder paste (on a QFP package). The difference is quite significant: the joints made by the soldering iron are inconsistent and in many cases not
Electronics Forum | Thu Nov 16 23:34:56 EST 2006 | mds33200
Hi, I am new in this industry and have purchased a beguinner unut, a 3-in-1 solder, desolder, hot air station. Currently I work on cellphone mainboards. At the moment I only replace single large chips on the mainboard. I would like to be able to repl
Electronics Forum | Fri Nov 17 15:12:26 EST 2006 | mds33200
Hi, I am located in Auburn Mass (USA) right near Worcester. Now I noticed you talked about micro stencil for a populated PCB, would I need one? Or could I use a syringe to lay a tiny dot of paste since im only replacing a chip or 2 (at the moment)? I
Electronics Forum | Fri Nov 17 16:24:18 EST 2006 | billwestiet
I'm in North Attleboro, small world. To answer your question, you can deposit small dots of paste with a syringe. Kind of tricky work, and there are small stencil soluions out there fairly inexpensively. See http://www.minimicrostencil.com/ (I do