Electronics Forum | Thu Dec 11 09:15:06 EST 2014 | sreejhu
Hello Sir, Thanks for your reply. i just got a mail from the DIMA service group and they said the Oven setting is as follows: Max temp settings in each zone (Which is not the temperature on your product, but close to where the air flow comes out of
Electronics Forum | Mon Dec 22 15:41:27 EST 2014 | benreben
why all people speak only the temperatur? the speed convoyor is very important too... with lesser zone of reflow you can lower the convoyor speed... but if i must speak about temperature and zone i think the minimum for solder all board in ROHS is 5
Electronics Forum | Wed Dec 10 16:14:37 EST 2014 | jimpat
The 300 degrees is the temperature as measured at the sensor. The actual air temperature just above your PCB may actually be much less. If the oven is properly calibrated then the 300 should represent air temperature at the board but I have seen ma
| 1 |
.gif)
winsouce.jpg)