Electronics Forum | Thu Jun 07 15:37:32 EDT 2001 | Claude_Couture
Kerryn, It's the first time I hear someone who needs an automated inspection machine to check the cleanliness of stencils. Why not improve on the cleaning method itself. I use ultrasonic batch cleaner. It takes 3 minutes to clean a stencil, 2 minutes
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Sun Nov 08 10:22:52 EST 2009 | doremi
Hi everybody, First of all, to have process under 100% control you should have AOI after every active process in the pcb assembly line : - Post printing (2D or 3D Solder paste inspection machine); - Post reflow; - Post selective(wave solder). It i
Electronics Forum | Fri Oct 14 14:09:19 EDT 2005 | bschreiber
Your problem is not the 0.4 pitch. Your problem is the manual cleaning. Manual cleaning will only remove the solder paste from the surface of the stencil. What's more, manual cleaning will force additional contamination into the 0.4 pitch apertures
Electronics Forum | Tue Jun 05 13:23:27 EDT 2001 | kerryn
We are a high-mix/low-volume operation and end up cleaning 40 - 50 stencils per day. Does anybody know of an automated inspection system or "scanner" that can check a stencil for cleanliness?
Electronics Forum | Thu Jun 07 13:40:12 EDT 2001 | kerryn
Dave, We have very short runs (less than one hour). We have stencils all over the place waiting to be cleaned. It is too time consuming to scope each stencil to inspect for cleanliness. Do you know of any automated or scanning devices that can ra
Electronics Forum | Tue Jun 05 16:40:46 EDT 2001 | kerryn
Thanks Phil. However, my objective is to identify stencils that are not 100% clean prior to sending to inventory. I want to catch it before the solder paste has a chance to dry and harden in the apertures. Kerry
Electronics Forum | Fri Dec 07 01:17:50 EST 2001 | Mike Konrad
The best suggestion one can offer is to view the archive section of this site. It is full of discussions, suggestions, advertising, claims, counter-claims, etc. Just search under the words �stencil cleaning�. Mike Konrad www.aqueoustech.com konrad
Electronics Forum | Tue Jun 05 20:45:54 EDT 2001 | davef
So, yer lookin' to detect a ~25um glob on the wall of the aperture on yer stencil, eh? Why not wash your stencils before you put them away? That's what we do. Give 'em a quick looksee, then rack 'em, if they're clean. Give 'em anudda looksee befo
Electronics Forum | Wed Dec 14 06:18:20 EST 2005 | tk380514
right again grant, consider the fact that if you spend enough time inspecting the soldered boards/pre-oven and check the BGA solder paste pads before, and clean the stencil regularly and check solder paste dryness, check oven profiles then after chec
Our Company handle AOI (Auto Optical Inspection) and SPI (Solder Paste Inspection) Machines.
Equipment Dealer / Broker / Auctions
Hwaseong-si, Gyeonggi-do, Korea
Hwaseong-si, South Korea
Phone: +82-1029254936
