Electronics Forum | Fri May 25 03:28:20 EDT 2007 | shparekh
Hi All, Brand new here. I am wondering if I can find a breakout board for 0.4mm pitch SMD connectors. TIA. -sanjay
Electronics Forum | Mon Oct 24 09:07:58 EDT 2016 | robl
Could you make up your own adaptor cable to connect to your programmer, then fit a small form connector like a Firewire on the edge of the PCB? It should only take up about 7x7mm of real estate as opposed to a 2.54mm 5x2 pin header 12.7 x 5.08, or a
Electronics Forum | Fri May 27 14:37:05 EDT 2005 | Frank
Look into the Juki KE-2060E machine. I have been extremely pleased with this machine. It will hold 80-8mm feeders, place 0201 (0603-metric) up to 74mm square ICs and BGA, 150mm long connectors. Up to 25mm tall components. It can handle up to 30 t
Electronics Forum | Thu Jun 02 18:16:26 EDT 2005 | URI
Look into the Juki KE-2060E machine. I have been > extremely pleased with this machine. It will > hold 80-8mm feeders, place 0201 (0603-metric) up > to 74mm square ICs and BGA, 150mm long > connectors. Up to 25mm tall components. It can > ha
Electronics Forum | Tue May 02 23:34:26 EDT 2006 | Frank
The 2060RE model that I have can do an 18"x20" board. I think the Mydata can do larger. Juki did tell me that next year they will release a machine that will do larger boards but didn't specify on how big. The 2060RE can do 0201 up to 74mm square
Electronics Forum | Wed Mar 29 03:40:06 EST 2006 | Frank
The Juki 2060 can have both front and rear trolleys and you do not loose any feeder locations. My question was why can't the Assembleon put trolley on the rear? I recently visited a friend at a company that used a lot of Assembleon and compared run
Electronics Forum | Wed Jun 18 09:01:09 EDT 2008 | markhoch
We're in the process of purchasing a couple new reflow ovens. The ovens that we're looking at have a standard clearance of 1.00"(25.4mm), when using the Edge Rail Conveyor. We can pay a few bucks extra in increase that to 1.5" (38.1mm). I think that
Electronics Forum | Tue Jan 29 08:21:50 EST 2019 | electronics101
Hi All, Can someone please help, I have a number of tall surface mount components that according to IPC 610 (8.2.2.3) are a fail due to the end termination not wetting at least 0.5mm + solder height. The components are very well soldered but the sol
Electronics Forum | Mon Jun 29 15:25:09 EDT 2020 | jmelson
Spoilt, OK, a good point in your message, what good is a machine with 15 mm component height capability if there are no feeders that support that tall a component! I hadn't thought about that aspect! (My Philips CSM84 is limited to 6.5 mm, and I r
Electronics Forum | Mon Dec 10 13:26:40 EST 2012 | dyoungquist
We are using our selective solder machine to solder a backplane with sixteen (16) 4x48 pin 0.080" connectors. Our first pass yield is about 85% meaning that 85% of the connectors come out with no bridges. Not quite as fine pitch as your connector a
