Electronics Forum | Wed Sep 26 12:16:44 EDT 2012 | bwjm
Hi Guys,recently i am facing an issue. Refer to the attached photo. This PCB is high RF speed, gold immersion single layer. After reflow, my solder seems to have black stains on it. I tried with SAC305 paste water soluble and no-clean, both results a
Electronics Forum | Tue Jun 07 10:24:59 EDT 2016 | davef
wlsmt: You’ve got to help us out here: * Why did you apply solder paste to capacitors prior to water washing the PCBA [where the caps were attached?]? * Did you reflow the Alpha WS-609? * How is the Alpha WS-820 involved in this? * Talk about the
Electronics Forum | Tue Jun 07 12:07:30 EDT 2016 | wlsmt
Sorry davef. I was not being clear. PCBAs came out cold soldered after being reflowed the first time with ALPHA WS-820. The flux gel ALPHA WS 609 was supposed to be applied only onto the terminations of caps where ALPHA WS-820 was for a second refl
Electronics Forum | Wed Jun 15 10:38:41 EDT 2016 | laynefelix
Hi everyone..i am new here. I am hardware design engineer and as per my experience PCBAs came out cold soldered after being reflowed the first time with ALPHA WS-820. The flux gel ALPHA WS 609 was supposed to be applied only onto the terminations of
Electronics Forum | Thu Jun 09 12:46:03 EDT 2016 | wlsmt
Tks DeanM
Electronics Forum | Fri Jun 17 14:55:01 EDT 2016 | wlsmt
Tks Laynefelix
Electronics Forum | Mon Jun 06 12:51:17 EDT 2016 | wlsmt
My operator applied flux gel ALPHA WS-609 on MG P/N FTH101XAP (CAP ALUM 100UF 50V 20% SMD) before aqueous washing the PCBAs. Solder paste used was ALPHA WS-820. Now the caps have yellow stains. Any solution to this is appreciated. Tks
Electronics Forum | Tue Jun 07 21:10:53 EDT 2016 | deanm
The first thing I would do is give Alpha a call and talk to their tech support about it.
Electronics Forum | Thu Aug 28 23:15:44 EDT 2014 | phyllishwl
Hi all, Our production reported that they found 3 panels out of 53 panels with strange phenomenon after reflow. 1/ Blister / Delamination of PCB panels, 2pcs blister/delamination under solder mask, 1pc under Gold plating at Gold finger 2/ Silkscr
Electronics Forum | Fri Aug 29 09:39:08 EDT 2014 | rgduval
I'll try to deal with the issues as you've presented them. 1. Blistering/delamination, shown in photo 2. The most likely cause of blistering/delamination like this is moisture in the boards. The moisture can get into the boards in multiple ways..
