Electronics Forum | Thu Oct 02 09:35:42 EDT 2008 | msangabriel
I have one brand new UV oven and 2 used ones. We used to cure Dymax conformal coating in this plant. We are selling those ovens.
Electronics Forum | Thu Oct 02 01:59:06 EDT 2008 | edmaya33
Obviously nobody can help you Jack. 1. its the camera for parts recognition ( enhanced CMOS ). 2. positioning system upgraded from ball screw to linear motor/gantry. before CPH=16500 new CPH=18000 using H12S
Electronics Forum | Thu Oct 02 16:29:11 EDT 2008 | kiss
Contact your local Fuji dealer. Your questions are covered on first couple of pages of spec. Your reluctantness to contact Fuji direct sounds as though you are a competitor scratching for info. Pick a phone, call Fuji.
Electronics Forum | Thu Oct 02 10:43:37 EDT 2008 | msangabriel
I am looking for companies that fabricates special or custom SMT feeders for an Fuji IP3 machine. It is to feed a SMT terminal. Do you know of any company that you can recommend?
Electronics Forum | Tue Oct 14 12:02:56 EDT 2008 | stepheniii
How much flux will be lost if you do that? And I would think that the paste would be too dry by the end of the shift. And don't forget that power rating of the oven doesn't mean that it is using that much power the entire time it's on.
Electronics Forum | Tue Oct 28 12:02:11 EDT 2008 | milas
Hi We have recently specified the following on a bareboard that has an ENIG finish. Does it sound about right or is it likely to give me problems ? Nickel : 3uM � 7uM Gold : 0.05 uM � 0.1 uM Thanks in advance
Electronics Forum | Fri Oct 31 08:02:14 EDT 2008 | davef
Here is some more reading on stencils for you: http://www.smtinfo.net/Db/_Stencil%20Printing.html
Electronics Forum | Tue Nov 04 10:02:21 EST 2008 | m79d
jerry this is what i wanted to hear 'real' measurements. I did not want to make the tooling strip too wide as that would add to the cost of the bare board. thank mickd
Electronics Forum | Fri Nov 14 02:56:15 EST 2008 | jlawson
Depending on budget Valor has Solutions from vManage software suite - depends on machine type on what can be done...but they are generally vendor neutral.
Electronics Forum | Sun Nov 16 09:02:47 EST 2008 | davef
While we're unfamiliar with Swisstone, we accept: * Techspray Solder-Wik * Chemtronics Soder-Wick * NTE Solder Wick All of these [and Swisstone] look basically the same. We wonder if maybe they're all made by the same source and branded differently