Electronics Forum | Sat Apr 03 05:21:33 EST 2004 | mattkehoe
There is a method for VIP you may not be familiar with. I dont want to go into depth here but check out http://www.sipad.com/sipadvip.htm and contact me off line if you want more info. Good luck. mk
Electronics Forum | Sat Mar 27 00:36:54 EST 2004 | Eric
Hi, I'm looking for an equipment to check on all the chip and ic placement pressure. Pls advise where can i find this type of equipment. Thanks.
Electronics Forum | Mon Mar 29 12:29:05 EST 2004 | Donn Bellmore
Placement pressure can be checked by using load cells. Both PCP and Entran make them and the amplifiers. They can be contacted at the following websites. PCP http://www.pcp.com Entran http://www.entran.com
Electronics Forum | Wed Mar 31 01:14:49 EST 2004 | Peter -CP40
Eric, You should be able to monitor the pressure of your nozzles by selecting: Diagnostics / Vacume check, depending on the type of machine you are running. When you cover the end of the nozzle, you should get a reading of about 500. This means it i
Electronics Forum | Wed Mar 31 19:07:31 EST 2004 | GDG
WE at AOI Services have all the remaining inventory of used and new parts from Photon Dynamics (CR Technologies and IRSI). We also offer technical services for these types of machines. Please look at our webpage for contact information. www.aoi-serv
Electronics Forum | Sat Mar 27 12:48:04 EST 2004 | Bill
Does anybody have access to an Electrovert Atmos 1000CR schematic? Ours has been removed from the manual ---and we could use information regarding the change from 480 to 220v for a different facility. Thanks in advance, Bill
Electronics Forum | Mon Mar 29 07:48:31 EST 2004 | check
I'M USING S-15 , S-20 AND F-3 MACHINES WITH UNIX LINE COMPUTER. THE TOOLING PART TAKES A LOT OF TIME HAVE YOU HEARD ABOUT A SOFTWARE THAT MAKE IT EASY AND FASTER ?
Electronics Forum | Mon Mar 29 12:33:48 EST 2004 | masr
Mark, I have almost 10 years of experince with Siemens equipment but I don't understand your question, what tooling you refering about, you mean reference run?
Electronics Forum | Mon Mar 29 11:51:55 EST 2004 | Claude_Couture
Hi all, Anyone familiar with BTU oven VIP-70. The control screen indicates that it is in IDLE mode. The recipe is running, but no heat is applied. The contactor for the heat is ON. All the electrical looks ok. I can't seem to be able to contact BTU,
Electronics Forum | Mon Mar 29 13:33:05 EST 2004 | Ron W
I was wondering if anyone has attempted to develop a process for the successful removal of a BGA and its underfill. Or, is it the general industry thought process that an underfilled BGA cannot be reworked.
