Electronics Forum | Fri Mar 22 17:14:15 EST 2002 | jseagle
What is the height, width, and length of the connector, packaging? We currently place a 2x20 2mm gull wing SMT connector measuring 8mm H x 38mm L x 6.1mm W, packaged on tape and reel with a plastic pickup in the center. We do this on an Assembleon
Electronics Forum | Tue Sep 17 17:39:26 EDT 2002 | fastek
Stephen- I'm not sure since I'm having trouble understanding your post whether you are knocking my post or not. If you did intend some sort of slight than let me clarify your concerns: 1) Claude is not using an MPA-G3 so H.D. is out. 2) I've used P
Electronics Forum | Mon Nov 04 16:54:13 EST 2002 | pjc
For me it was the 1.0mm nozzle, if we're talking mini-MELF here. Also, slowing the turret speed helps. Had mine at 30%. Results vary if placing on paste vs. glue. Paste is better. Still, the std. 1.0mm nozzle is where near as good as with the MELF no
Electronics Forum | Fri Nov 22 08:57:56 EST 2002 | davef
Q1: What do you mean by "if the board is manufactured properly"? A2: If the epoxy is noy cured prooperly, for instance, the copper will not be well attached to the glass. So, peel strength will be lower. Q2: I don't believe that the peel off/or lif
Electronics Forum | Fri Jan 31 14:33:37 EST 2003 | joeherz
Dave, I do have the mechanical drawings but no electronic versions. After looking at the cost of setting up for N2 I decided against it for now, BTW. If you think about it, having an air knife on this nozzle would tend to negate the negative effec
Electronics Forum | Tue Jul 06 07:49:08 EDT 2004 | davef
Q1)What is the MSD level for PCB? A1) There is none Q2)I have some PCB's with HIC (humidity indicator card ) has turn to pink at 50%. Should I bake the PCB prior to assembly process.This fab is a complex board with various kind advance package assem
Electronics Forum | Tue Nov 09 10:44:13 EST 2004 | russ
I guess i might want to throw this in for future reference. After speaking with our board supplier he states that this mask is fully cured when it reaches approximately 180C. I beleive this since we usually probe the repaired area after putting the
Electronics Forum | Wed May 03 22:33:57 EDT 2006 | ramerez
I am based in Nogales and I have also tried the MS2, I was told to immediately cancel my trials, It did reduced the build up of dross but the mess it made to the wave and the surrounding areas was very bad, Everything was coated black and the smell a
Electronics Forum | Thu Jan 19 13:53:06 EST 2006 | sarar
Hey guys - our lab has some data and photographs available for the MS2 for use in wave solder from some of the studies we have performed for P Kay. There are other versions being studied, but that is the only version available to market currently.
Electronics Forum | Wed May 03 22:41:36 EDT 2006 | ramerez
I am based in Nogales and I have also tried the MS2, I was told to immediately cancel my trials, It did reduced the build up of dross but the mess it made to the wave and the surrounding areas was very bad, Everything was coated black and the smell a