Electronics Forum | Wed Feb 18 11:21:14 EST 2004 | Mike Konrad
You have two choices� Change your paste or beef-up your wash chemical. I�ll let others discuss paste options but as far as wash chemical is concerned, consider chemicals specifically designed for such applications. Zestron is promoting A300 as sui
Electronics Forum | Wed Dec 12 11:22:52 EST 2001 | davef
WOW, a 300ml syringe!!!! Now, that is one BIG-assed syringe. [I assume you mean �30ml�] Thoughts are: * Buy through distribution, for instance http://www.loctite.com/distributor/ * Buy your cases in smaller syringes. 10 & 30ml syringes are standar
Electronics Forum | Tue Feb 26 07:45:33 EST 2013 | cyber_wolf
We have had a 300 for about three years. The mechanicals are pretty solid, but the software has much to be desired in my opinion. It is not intuitive.You have to drill into several layers and navigate all over the place to make simple changes. Mecha
Electronics Forum | Thu Oct 02 09:24:15 EDT 2003 | johnpatricelli
Did not do the verification of replenishing reels at the last company I was with, and it bit us hard on a 300+ piece build, over 30 placements per board on 0603 size (if I remember right) were built right on 7 boards, then they ran out of reel 1, and
Electronics Forum | Wed Jul 16 12:13:27 EDT 2014 | deanm
Thank you for your comments so far. I believe I threw some people off by my wording. Clarification: How feasible is it to run a board straight into the reflow oven without inspecting it first for any placement defects? Is nudging parts and performin
Electronics Forum | Tue Jun 12 11:10:08 EDT 2012 | dyoungquist
We run 1 high mix/low volume line using a MY12 with the MyLabel and MyPlan software. The MyLabel software helps reduce setup times while tracking quantities on the reels and is well worth the investment in our opinion. As for needing extra reels on
Electronics Forum | Fri Sep 15 16:37:49 EDT 2000 | Dave F
Sounds like someone aimin� fo tha big hurt, if ya axes me. Two spots to place your lawn darts are: 1 J Hwang in "Modern Solder Technology � " states (p.354) that " � extreme CTE mismatch between silicon IC (~2) and the PCB (~16), solder connections
Electronics Forum | Wed Dec 10 15:18:44 EST 2003 | Dustin
My name is Dustin Steedman. I have a Direct Hire position available in Michigan. I realize that you may be currently employed. However, I am sending you this email with the hope that you or someone that you know would be interested in this current op
Electronics Forum | Wed Dec 10 15:21:37 EST 2003 | Dustin
My name is Dustin Steedman. I have a Direct Hire position available in Michigan. I realize that you may be currently employed. However, I am sending you this email with the hope that you or someone that you know would be interested in this current op
Electronics Forum | Fri Nov 21 12:12:44 EST 2014 | joe98375
On average there are about 3 parts per board that get hand placed (x24 is 72 parts per panel). One of these parts is a big 1W resistor that cannot fit on our axial machine. We also have a Zener Diode that needs to be hand placed because its leads are
