Electronics Forum | Thu Jun 28 20:11:32 EDT 2007 | rfrog
Hi folks, I've been bouncing off of MyData technical support for some time on an issue with a MyData machine. Seems that this My9 likes to skip an 0402 placement at a rate of ~ 1000/million. Profile: MyData My9 Mechanical centering Midas only
Electronics Forum | Tue Jul 10 16:13:52 EDT 2007 | bk
Hi folks, I've been bouncing off of MyData > technical support for some time on an issue with > a MyData machine. Seems that this My9 likes to > skip an 0402 placement at a rate of ~ > 1000/million. > > Profile: MyData > My9 Mechanical ce
Electronics Forum | Thu Jan 03 17:00:20 EST 2008 | davef
Recommended procedure for soldering stainless steel [Atlas Steels Australia]: * Surfaces must be clean and free of oxidation. * A rough surface improves adherence of the solder, so roughening with grinding wheel, file or coarse abrasive paper is reco
Electronics Forum | Fri Mar 21 15:51:23 EDT 2008 | g2garyg2
Thought I would reply and try to assist. PROMATION, my company, also manufactures Diode Laser soldering systems but with this stated we also manufacturer iron tip systems, soft beam systems and hot air solutions. The reasons are simple. Diode Laser
Electronics Forum | Mon Apr 14 13:24:32 EDT 2008 | mmjm_1099
We had an order using a 2up PCB (same manufacturer) with same components and same board layout without any problems. Perfect run. The next order ran on the same day with same paste using same parts, same layout, same profile, but different 2up PCB h
Electronics Forum | Wed May 14 12:35:34 EDT 2008 | rgduval
Thanks, Chunks. That's the one point of the experiment that we haven't tried yet. Though, we came to the same conclusion just yesterday. Dave, so far, the most help we've gotten was from the paste manufacturer. I've involved the board house, but
Electronics Forum | Mon May 12 18:45:57 EDT 2008 | locostpp
Hi All, We are embarking on the design of an ultra low-cost pick and place machine for use by small manufacturers & would appreciate some input. Here are some points: Low cost - in the region of $6-11k (higher cost versions faster) Two cameras (up
Electronics Forum | Thu May 29 12:06:25 EDT 2008 | bsumfg
This thread is a pleading for all those PCB Design experts. A good design person with experience will design for manufacturing as well as to please the customer. Actually that goes hand-in-hand. If a board is designed well from a manufacturing standp
Electronics Forum | Tue Jun 24 13:46:21 EDT 2008 | bschreiber
I know it is not what you want to hear, but first and foremost, you must consult your local regulating agencies and here is why: Solder paste contains heavy metals. We are all familiar with the problems associated with lead, but lead free solder pas
Electronics Forum | Thu Jan 29 19:01:51 EST 2009 | stevek
Allow me a contrary viewpoint. I've had these things on my floor and had customers get outsourced evaluations done with them. Most expensive boat anchors I've run across. First the good points: The automated scanning and pattern recognition is go