Electronics Forum | Sat Aug 21 15:02:32 EDT 2010 | jry74
I have a pcb with 750 plated through holes that get Holtite sockets inserted into them. I have a method of pressing in 10 sockets at a time. However, when we are done, the board has bad warpage on the X and Y axis. Does anyone out there have any t
Electronics Forum | Mon Oct 04 11:34:29 EDT 2010 | vetteboy86
I've done minimal research to this point and understand my issue with solder on the double sided boards is due to oxidation that occures on the unpopulated pads when the board makes its first trip through the reflow oven. We did run both sides in a
Electronics Forum | Thu Oct 07 15:17:57 EDT 2010 | debron1
I am trying to repair two Simplematic 8130 board loaders. I have the same error on both of them. The error says " NO PLC Loaded." I don't believe that it is the plc but instead the display "uticor" system. Can anyone give some advise on how to fix th
Electronics Forum | Sat Jan 22 18:16:05 EST 2011 | eadthem
Hey "vpblf" i was wondering if you had herd much from mirtec about fixes for the repair plus issues?(good image duplicated on bad image, no arrows, missing good or bad images, missing problems, problems from a different board showing up under the wro
Electronics Forum | Fri Dec 10 09:49:08 EST 2010 | reic1
We recently purchased at auction a KANETIC KTT4402D board turner for our SMT line. Little did I realize that there is no way to contact the company. does anyone have one of these units? I need manuals. I stumbled across a password that gets me to
Electronics Forum | Fri Dec 17 09:04:17 EST 2010 | wolverine
We have an older model CP40-LV that will start out the day with blurry and double vision, then after about twenty minutes of just idling, the vision slowly improved until the machine could find the board fiducials and do a passable placement job. Th
Electronics Forum | Sun Dec 26 23:33:38 EST 2010 | raghu
Thanks for your reply sir, We have done production with Machine application earlier, of control electronics sub- assys of some boards with acrylic conformal coating by using one tank... And some boards with polyurathan conformal caoting by usin
Electronics Forum | Fri Jan 07 10:27:50 EST 2011 | rpatel28364
We havn't done any failure analysis on this BGA. We have this information from customer. currently we dont have anything to check solderability for BGA. Only thing we rly is Profile on solder sample un populated board. Also we are building only 100 u
Electronics Forum | Tue Jan 18 18:12:27 EST 2011 | eadthem
Theres something to be said for having a machine operator or inspection person carry the board from the output to the oven. Id say about 1/2 of our issues are fixed/noticed in this simple step of transferring the board from the PNP to the oven. If
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha